Subscribe to Our Youtube Channel
Related Manuals for Firman W01682F
Summary of Contents for Firman W01682F
- Page 1 OPERATOR’S MANUAL PORTABLE INVERTER GENERATOR MODEL NUMBER W01682 Rev Level:01 Record product information to reference when ordering parts or obtaining warranty coverage. P/N:316745451 Rev:01...
-
Page 2: Table Of Contents
Table of Contents Introduction ......1 Trouble Shooting .....22 Safety Precautions . -
Page 3: Introduction
Save these original instructions for future reference. This manual covers operation and maintenance of the FIRMAN generators. All information in this publication is based on the latest production information available at the time of approval for printing. -
Page 4: Safety Precautions
SAFETY PRECAUTIONS • DANGER POISONOUS GAS HAZARD. • • • • English Page 02 Customer Service: 1-844-FIRMAN1... -
Page 5: Incorrect Usage
CORRECT USAGE Example location to reduce risk of carbon monoxide poisoning • ONLY use outside and downwind, far away from windows, doors and vents. • Direct exhaust away from occupied spaces. INCORRECT USAGE Do not operate in any of the following locations: Near any door, window or vent Garage Basement... - Page 6 WHEN OPERATING EQUIPMENT WARNING • DO NOT operate this product inside any Starter cord kickback (rapid building, carport, porch, mobile equipment, retraction) will pull hand and arm marine applications, or enclosure. • toward engine faster than you can DO NOT tip engine or equipment at angle let go which could cause broken which causes fuel to spill.
- Page 7 WARNING • DO NOT touch bare wires or receptacles. Unintentional sparking • DO NOT use generator with electrical cords could cause fire or which are worn, frayed, bare or otherwise electric shock resulting damaged. in death or serious • DO NOT operate generator in the rain or injury.
-
Page 8: Unpacking The Generator
NOTE: 1. Engine Oil(Bottle) ..... . . 1 Improper treatment of generator could damage 2. Oil Funnel ....... 1 it and shorten its life. -
Page 9: Controls And Features
CONTROLS AND FEATURES Generator ⑫ ⑦ ① ② ③ ⑨ ⑩ ⑪ ⑧ ⑥ ⑤ ④ Carrying Handle 2- Fuel Lever Vent – Turn this valve to the “On” position to supply air to the tank. 3- Fuel Cap 4- Control Panel 5- Recoil Starter 6- Muffler/Spark Arrester 7- Spark Plug Access Cover... -
Page 10: Control Panel
Choke Knob Parallel Operation Outlets - These outlets are used for connecting two FIRMAN inverter generators for Economy Control Switch parallel operation. A FIRMAN parallel kit(optional The Economy Control switch can be activated in order to equipment) is required for parallel operation. -
Page 11: Specifications
Motors and Generators. AN IMPORTANT MESSAGE ABOUT TEMPERATURE: Your Firman Power Equipment product is designed and rated for continuous operation at ambient temperatures up to 40°C (104°F). When your product is needed, your product may be operated at temperatures ranging from 5°F (-15°C) to 122°F (50°C) for short periods. If the product is exposed to temperatures outside this range during storage, it should be brought back within this range before operation. -
Page 12: Add Engine Oil
Add Engine Oil NOTICE: DO NOT attempt to crank or start the engine before it has been properly filled with the recommended type and amount of oil. Damage to the generator as a result of failure to follow these instructions will void your warranty. NOTE: The recommended oil type is 10W-30 automotive oil. -
Page 13: Add Fuel
Add Fuel Fuel must meet these requirements: • Clean, fresh, unleaded gasoline. • Use regular UNLEADED gasoline with the generator engine with a minimum 87 octane / 87 AKI (91 RON). For high altitude use, see "Operation at High Altitude". •... -
Page 14: System
OPERATION WARNING Generator Location Generator voltage could cause WARNING electrical shock or burn resulting in death or serious injury. Make sure you review each warning in order to prevent fire hazard. • • Keep area clear of inflammables or other DO NOT touch bare wires or receptacles. -
Page 15: Surge Protection
• Starting the Generator Operate this product ONLY outside far away from windows, doors and vents to reduce 1. Before starting the generator, check for loose the risk of carbon monoxide gas from or missing parts and for any damage which accumulating and potentially being drawn may have occurred during shipment. -
Page 16: Connecting Electrical Loads
6. Pull the choke lever out to the “START” position. bones, fractures, bruises, or sprains resulting in serious injury. When starting engine, pull cord slowly until resistance is felt and then pull rapidly to avoid kickback. Keep choke lever in “START” position for only 1 pull of the recoil starter. -
Page 17: Economy Control Switch
2. Press the engine switch to the “OFF”(O) position. Do not leave the generator until it has completely stopped. Economy Control Switch 3. Turn the fuel valve to the “OFF”(O) position. The Economy Control switch can be activated in order to minimize fuel consumption and noise while operating the unit during times of reduced electrical output, allowing the engine speed to idle during periods of non-use. -
Page 18: Low Oil Shutdown
2.Restart engine and if the engine stops again operated in parallel to increase the total available a low oil condition may still exist. DO NOT try electrical power to 3100 watts. A FIRMAN parallel to restart the engine. kit (optional equipment) is required for parallel 3.Contact an Authorized FIRMAN Service Dealer. -
Page 19: Maintenance And Storage
MAINTENANCE AND STORAGE MAINTENANCE SCHEDULE Every Daily(Before Initial Every Every 100 hours ITEM NOTES operation) 25 hours 50 hours 250 hours (or annual) Check condition. Adjust gap √ Spark Plug and clean. Replace if necessary. √ Check oil level. Engine Oil √... -
Page 20: Engine Maintenance
• ENGINE MAINTENANCE Use fresh and high quality lubricating oil to the specified quantity. To prevent accidental starting, remove and If contaminated or deteriorated oil is used or ground spark plug wire before performing any the quantity of the engine oil is not sufficient, service. -
Page 21: Spark Plug Maintenance
Spark Plug Maintenance Inspect Muffler and Spark Arrester Changing the spark plug will help your engine Inspect the muffler for cracks, corrosion, or to start easier and run better. other damage. Remove the spark arrester, if (a) Remove the spark plug cover. equipped, and inspect for damage or carbon blockage. -
Page 22: Generator Maintenance
GENERATOR MAINTENANCE Make certain that the generator is kept clean and stored properly. Only operate the unit on a flat, level surface in a clean, dry operating environment. DO NOT expose the unit to extreme conditions, excessive dust, dirt, moisture or corrosive vapours. NOTICE: DO NOT use a garden hose to clean the generator. -
Page 23: Service And Storage
SERVICE AND STORAGE WARNING Drain fuel into approved container outdoors, Infrequent Service away from open flame. Be sure engine is cool. If the unit is used infrequently, difficult starting Do not smoke. may result. To eliminate hard starting, follow 4-FUEL STARVATION: Start and run the generator these instructions: until stops from lack of fuel. -
Page 24: Trouble Shooting
TROUBLE SHOOTING Problem Cause Correction 1. Circuit breaker is open. 1. Reset circuit breaker. 2. Fault in generator. 2. Contact authorized service facility. Engine is running, but no 3. Poor connection or defective cord 3. Check and repair. AC output is available. set. -
Page 25: Parts / List/ Wiring Diagram
PARTS DIAGRAM AND PARTS LIST W01682 Parts Diagram Page 23 English Customer Service: 1-844-FIRMAN1... - Page 26 80cc Engine Parts Diagram Page 24 English Customer Service: 1-844-FIRMAN1...
-
Page 27: Engine Parts Diagram
W01682 Parts List Description Qty. Description NO. Part Number NO. Part Number Qty. 317713500 Screw M4×10 Fuel Guide 317713550 317713501 317713551 Fuel Hose 2 Cover, Top Fuel Valve 317713502 Screw M5×14 317713552 317713503 Clamp 1 Right Side Cover Assy 317713553 Fuel Hose 4 317713504 317713554... -
Page 28: Parts List
SPE80 80cc Engine Parts List Qty. Qty. NO. Part Number Description NO. Part Number Description Bolt M6×12 Setting Flash Board 317723500 317723552 317723501 Starter Assy. 317723553 Muff. Protector Seal Bolt M6×15 317723502 317723554 317723503 317723555 Breather Pipe Air Shroud Comp. Cyl. -
Page 29: Wiring Diagram
Wiring diagram Page 27 English Customer Service: 1-844-FIRMAN1... -
Page 30: Warranty
FIRMAN GENERATOR will register the warranty upon receipt of your Warranty Registration Card and a copy of your sales receipt from one of FIRMAN’s retail locations as proof of purchase. Please submit your warranty registration and your proof of purchase within ten(10) days of the date of purchase. -
Page 31: Installation, Use And Maintenance
Limits of Implied Warranty and Consequential Damage FIRMAN disclaims any obligation to cover any loss of time, use of this product, freight, or any incidental or consequential claim by anyone from using this product. THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF MERCHANT ABLILITY OR FITNESS FOR A PARTICULAR PURPOSE. -
Page 32: Emission Control System Warranty
If any such part fails during the period of warranty coverage, the part will be repaired or replaced by FIRMAN at no charge to the owner. Any such part repaired or replaced under the warranty will be warranted for the remaining warranty period. - Page 33 Service – Warranty (8) Throughout the emissions warranty period defined in Subsection (b)(2), FIRMAN will maintain a supply of warranted parts sufficient to meet the expected demand for such parts. (9) Any replacement part may be used in the performance of any warranty maintenance or repairs and must be provided without charge to the owner.
Need help?
Do you have a question about the W01682F and is the answer not in the manual?
Questions and answers