Page 1
DOME CLIMBER TM10024 USA office: Fontana GBR office: Ipswich AUS office: Truganina If you're having difficulty, our friendly USA:cs.us@costway.com AUS:cs.au@costway.com customer team is always here to help. GBR:cs.uk@costway.com THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE.
Before You Start Please read all instructions carefully and keep it for future reference. Warnings Attention: For home use only. Attention: Children should use this product under the parental supervision. Danger: Keep all small parts and packaging materials for this product away from babies and children, otherwise they may pose a choking hazard.
SAFETY INSTRUCTIONS ● To prevent entanglement and strangulation, dress children appropriately, using well-fitting shoes and avoiding ponchos, scarves, jackets with neck drawstrings, helmets with straps, and FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN other loose-fitting clothing that is potentially hazardous while using SERIOUS INJURY OR PROPERTY DAMAGE.
Page 4
PLAYGROUND AND SURFACE NOTE: An initial fill level of 12 inches (30 cm) will compress to MATERIALS INSTRUCTIONS about a 9 inch (23 cm) depth of surfacing over time. The surfacing will also compact, displace, and settle, and should be periodically refilled to maintain at least a 9 inch (23 cm) depth.
ASSEMBLY INSTRUCTION BEFORE BEGINNING ASSEMBLY Identify and check all parts and hardware using the PART LIST in Dome Climber Assembly this document. Make sure that all parts and accessories are intact and complete before assembly. Test all bolts by inserting them into Step 1: Bottom Circle Assembly their respective holes.
Page 6
Tips: The order of the poles needs to be the same as the order Step 2: Second Circle Assembly marked in the following picture. First, pick up four blue poles (L), one long bolt (E), one normal The outermost pole is pole ①, the second is pole ②, the third is pole washer (H) and one thin nut (G).
Page 7
Step 3: Second Circle Assembly Step 4: Roof Assembly First, pick up one blue pole, one yellow pole, one long bolt (E), one First, pick up one yellow pole(A), two yellow poles (B), one long bolt normal washer (H) and one thin nut (G). (E), one normal washer (H) and one thin nut (G).
Page 8
Step 5: Black Grip Assembly ( Important: check all fixed fasteners are fully tightened) First, fasten the black grip (C) on the node with a long nut (D) using the tool Part I. NOTE: All of the nodes will need a grip, except the nodes of the bottom circle.
Need help?
Do you have a question about the TM10024 and is the answer not in the manual?
Questions and answers