Optical Drive - Dell 6400 Owner's Manual

1 battery-bay latch release
5 Remove the optical drive, if installed, from the optical drive bay. See "Optical Drive" on page 111.
6 Press the power button to ground the system board.
7 Remove any installed cards from the ExpressCard slot (see page 66) and the 5-in-1 media memory card
reader (see page 68).
8 Close the display and turn the computer upside down on a flat work surface.
9 Remove the hard drive (see page 112).

Optical Drive

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
1 Turn the computer over.
2 Remove the optical-drive security screw.
3 Insert a scribe into the notch and push it to the side to release the drive from the bay.
4 Slide the drive out of the bay.
1
2 battery
2
Adding and Replacing Parts
111