arboleaf KX-707A Manual
![]()
Product description
![arboleaf - KX-707A - Product description Product description]()
Key operation method
- Press and hold the power button (
) for 2 seconds to turn it on or off. - (
) Power button, short press to switch modes, and the color of the button lights changes to blue (soothing mode) and purple (strong mode) respectively - The right (
) key is for strength selection, with three levels of strength and colors of blue, orange, and purple. Corresponding to gears 1-3 respectively. - The left (
) key is for temperature selection, with three temperature levels and colors of blue, orange, and purple. Corresponding to gears 1-3 respectively
Usage
Put your hands into the massager, insert your fingers into the cloth cover, and then start the machine.
![]()
Charging operation method
- Connect and tighten both ends of the charging cable. The power button indicator light is flashing red, indicating that the connection is correct and charging is in progress.
- The indicator light stops flashing, and the color of the power button changes to blue, indicating that the charging is complete.
Tip:
When the red indicator light flashes, please charge it in a timely manner. The product can only be charged when it is turned off.
The purpose of the small hole at the bottom of the product is to insert a toothpick or sewing needle and press it in case the air pressure cannot be released normally, which can cause the product to come to an emergency stop (optional).
Product parameters
Product Name: Hand Massager Product | Model: KX-707A |
Product net weight: 730g | Charging specifications: DC 5V/1A |
Body material: ABS | Product size: 190mm x 195mm x 111 mm |
Battery capacity: 1800mAh | Rated Power: 6W |
Massage mode: 2 types | Heating temperature value: 38 ºC/42 ºC/45 ºC |
Operating environment temperature: 0-40 ºC | Full charge usage time: about 2 hours |
Charging time: about 2 hours | Working cycle: 15 minutes |
Executive standard: GB4706.1- 2005 GB4706.10-2008 |
Troubleshooting
If there is a fault during the operation of this product, please check it. If the fault cannot be eliminated or the product still cannot be operated, please turn off the power and contact the service center of this product for maintenance.
Possible situation | Possible reasons | Measures |
The Product cannot work | Low battery | Charging |
Pressing the power button in the wrong position or not enough time. | Press the correct position for 2 seconds and release. |
Product is charging | Use after charging |
If the idle time is too long the battery will generate discharge protection. | Customer service, activate the battery |
The product cannot be recharged | The charger connection plug is not in place. | Please reinsert until the charging display appears |
Damaged charging cable plug | Please replace the charging cable |
The charger used, the charging cable does not meet the product requirements. | Please match according to the technical parameters provide in the manual |
The product can not be charged when it is turned on | Charge the product after it is turned Off |
The product can be turned on, but the function cannot work | Low battery | Charging |
The massager is not strong enough | The strength choice is not suitable, or low battery | Please follow the user manual |
Please do not disassemble or try to repair by yourself. Once disassembled, we will not be responsible for it.
Palm acupuncture point
![arboleaf - KX-707A - Palm acupuncture point Palm acupuncture point]()
Attention
- It is not recommended for minors to use this product. If necessary, please operate under adult supervision.
- For those with sensitive skin, please use with caution.
- Do not use when experiencing pain and discomfort.
- Do not immerse this product in water or use it in the rain.
- It is prohibited to throw the product into a fire or near a fire source.
- Unauthorized modification of this product is prohibited.
- It is prohibited to operate and charge this product without human intervention.
- In case of physical injury, consult a doctor before use.
- This device has a heating function and is prohibited from being used for a long time by heat sensitive individuals to prevent low-temperature burns.
- Do not use this product while charging.
This product is only used as a physical therapy health product and is not intended for use as a medical device.
Emergency handling methods:
- In case of accidental falling into a fire, falling from high altitude, stacking of heavy objects, cutting of the body, and other special circumstances, In case of emergency situations such as odor, smoke, fire, or explosion caused by the machine, the onlookers should be immediately evacuated and the after-sales service should be called for handling. Unauthorized disassembly is strictly prohibited.
- If accidentally falling into the water, it should be immediately removed from the water and placed in a nearby, open environment without flammable or explosive materials. It is also necessary to call the after-sales service immediately for handling, and unauthorized disassembly is strictly prohibited.
- If the product cannot be shut down or operated normally, there is a small hole in the STOP position at the bottom of the product. Use a toothpick or sewing needle to insert it and press it to emergency stop the product.
Taboos:
Without the doctor's permission, this product cannot be used in any of the following situations: pregnancy, cancer patients, complications of diabetes (such as neuropathy or retinal damage), wearing a pacemaker, recent surgery, epilepsy or migraine Intervertebral disc herniation, anterior displacement of the spine, vertebral detachment, or spinal joint stiffness, recent joint replacement surgery or IUD, metal needles or plates, any issues related to your physical health.
- Wipe the surface of the device with a slightly damp towel, then dry it with a dry towel and place it in a dry and ventilated place.
- Please do not place in high temperature, humidity, or direct sunlight.
- When the storage period exceeds 2 months, the box should be opened for inspection and charged
- Massagers are strictly prohibited from being heavily pressed, and the maximum stacking height of product packaging is prohibited from exceeding 2 meters.
- This massager is suitable for transportation modes such as cars, trains, ships, and airplanes.
- Ensure proper transportation fixation to prevent severe vibration, collision, rolling, and falling during transportation.
Documents / ResourcesDownload manual
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download arboleaf KX-707A Manual
Need help?
Do you have a question about the KX-707A and is the answer not in the manual?
Questions and answers