Table of Contents
Advertisement
Information on laundry ...
Labelling of fabrics
Follow the manufacturer's care information.
Drying at normal temperature.
Drying at a lower temperature
Do not machine dry.
The safety information MUST be observed
Do not tumble-dry the following fabrics for example:
– Airtight fabrics (e.g. rubber-coated fabrics).
– Delicate materials (silk, curtains made from synthetic material)
– Laundry contaminated with oil.
Before using the dryer for the first time
– Do not put any laundry inside the dryer. Turn the programme selector to Timed
Programmes (
page 7) and press
programme, turn the programme selector to stop (Off).
Drying tips
– To ensure a consistent result, sort the laundry by fabric type and drying programme.
– Always dry very small items (e.g. baby socks) together with larger items (e.g. hand towels).
– Close zips, hooks and eyelets, and button up covers. Tie cloth belts, bands, etc. together.
– Do not over-dry easy-care laundry
Allow laundry to finish drying in the air.
– Do not iron laundry immediately after drying, fold items up and leave for a while
the remaining moisture will then be distributed evenly.
– Knitted fabrics (e.g. T-shirts, jerseys) often shrink during their first drying.
Do not use the extra seco (Very Dry) programme.
– Starched laundry is not always suitable for dryers
adversely affects the drying operation.
– Use the correct dosage of fabric softener as per the manufacturer's instructions when
washing the laundry to be dried.
– Use the timer programme for small loads
Environmental protection/energy-saving tips
– Before drying, spin the laundry thoroughly in the washing machine
speed, the shorter the drying time will be (consumes less energy), also spin easy-care
laundry.
– Use the maximum recommended capacity, but do not exceed it
Programme overview, page 7.
– Make sure the room is well ventilated during drying.
– Clean the fluff filter after every drying operation
– Do not obstruct or seal up the air inlet.
select
delicado (Low Heat) as well.
page 11!
they may crease.
inicio/stop (start/stop). At the end of the
risk of creasing!
starch leaves behind a coating that
this improves the drying result.
the higher the spin
page 4.
Care and cleaning
Dryer housing, control panel, air inlet, moisture sensors
– Wipe off with a soft, damp cloth.
– Do not use harsh cleaning agents/solvents.
– Remove detergent and cleaning agent residue immediately.
or if depósito (container) / limp.
Air cooler / Protective filter
To clean, remove the protective filter only! Clean the air cooler behind
the protective filter once a year!
– Allow the dryer to cool.
– Residual water may leak out, so place an absorbent towel underneath
the maintenance door.
1. Unlock the maintenance door (1).
2. Open the maintenance door fully (2).
3. Turn both locking levers outwards (1).
4. Remove the front insert (2).
5. Remove the air cooler.
Do not damage the protective filter or air cooler!
When cleaning, use warm water only. Do not use hard or sharp-edged objects.
6. Clean the protective filter/air cooler completely. Let it drip completely dry.
Clean the seals.
7. Insert the protective filter/air cooler first (handle facing down), then the
front insert.
8. Turn back both locking levers.
Moisture sensors
The dryer is equipped with stainless steel moisture sensors. Moisture sensors measure
how damp the laundry is. A thin layer of limescale may build up on the moisture sensors
after prolonged use.
1. Open the door.
2. Clean the moisture sensors using a slightly damp sponge with a rough
surface.
Do not use steel wool or abrasive materials.
5
Only when switched off!
Clean protective filter 5 or 6 times a year
(clean) flashes after cleaning the fluff filter.
/
6
Advertisement
Table of Contents
