Table of Contents
Advertisement
Installation
towels
towels/
Tea
– Delivery specification: dryer, instructions for installation and use.
– Check dryer for transport damage.
towels
Terry
– The dryer is very heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
linen
Table
– Do not set up in a room that is susceptible to frost.
Freezing water may cause damage.
– If in doubt, have the appliance connected by an expert.
linen
Bed
Setting up the dryer
1.
– The appliance plug must always be accessible.
Socks
– Ensure that the appliance is installed on a clean, level
and firm surface.
– Keep the air inlet on the front of the dryer clear.
Underwear
– Keep the area around the dryer clean.
– Adjust the height of the dryer using the threaded
bathrobe
feet at the front.
Terry/
Do not remove the threaded feet under any
circumstances.
Anoraks
Do not install the dryer behind a door or sliding
door, as these may prevent the dryer door from
clothing
Work
opening.
Observing this instruction may stop a child from
becoming shut inside the dryer and having its life
Sportswear
put in danger.
Skirts/dresses
Mains connection
safety information
2.
– Connect to an AC earthed socket. If in doubt have the socket checked by an expert.
Trousers
– The mains voltage and the voltage shown on the rating plate (
– The connected load and necessary fuse protection are specified on the rating plate.
Changing the power input
Shirts
3.
T-shirt
Press and hold the
Set to stop
(Off).
(Low heat) button and turn the
programme selector once to.
Frost protection / Transport
Preparation
Empty the condensation container
The dryer contains residual water;
7
this can flow out if the dryer is tilted.
Technical data
Dimensions (DxWxH)
60 x 60 x 85 cm
Weight
approximately 35 kg
Max. capacity
7 kg
Condensation container
approx. 4.2 l
Ambient temperature
5 - 35 °C
Connection voltage
220 - 240 V
Connected load
2025 / 2600 W
Fuse protection
10 / 16 A
Take all accessory parts out
Product number
Rating plate or inside of the door
of the drum. The drum must
Production number
be empty.
You can find the rating plate on the back of the dryer.
Consumption rates
These are guide values determined under standard
conditions. Deviations of up to 10 % are possible. The value
on the label is achieved at the maximum heat setting.
Spin speed in rpm
(residual moisture)
resistentes/algod.
(Cottons)
7 kg
seco armario
1400 (aprox. 50%)
(Cupboard Dry)*
Clean and level
1000 (aprox. 60%)
Make sure that the air inlet
800 (aprox. 70%)
remains unobstructed
seco + (Iron Dry) *
1400 (aprox. 50%)
1000 (aprox. 60%)
page 11.
800 (aprox. 70%)
sintéticos (Easy-Care)
3.5 kg
Page 9) must correspond.
seco armario
800 (aprox. 40%)
(Cupboard Dry)*
Ensure that the socket is fused.
600 (aprox. 50%)
or
10 A
16 A
*Test program to DIN EN 61121.
**The values may deviate from the values shown here, because of over/undervoltage, type of
fabric, composition of the laundry to be dried, residual moisture in the material and size of the
load.
delicado
Optional accessories
To change the power
Set to stop
(order from the after-sales service using the order number)
input, press the
(Off).
menos (Easy-iron) button.
Washer-dryer stack connection set
WZ
20311
The dryer can be placed on top of a suitable washing machine with the same width and depth
Do not operate the dryer if there
to save space. This connection set must always be used to secure the dryer to the washing
is a danger of frost.
machine. If the worktop of the washing machine is less than 544 mm deep, please consult
the after-sales service or your specialist retailer.
Platform
WZ
20460
For easier loading and unloading. The basket in the pull-out can be used for carrying the
page 4.
laundry.
Installation underneath the worktop
WZ
Risk of electric shock.
20295
Instead of the appliance covering plate, you must have a metal cover fitted by an expert.
8
What to do if ...
Repairs must only be carried out by the after sales service or an authorised expert.
Before you contact the after-sales service, please make sure that you are unable to resolve
the problem yourself. You will be charged for advice if a technician is called out, even during
the warranty period. You can find your nearest after-sales service in the enclosed list. When
contacting the after-sales service, please quote the appliance's product number (E-Nr.) and
production number (FD) (
on the inside of the door).
The
inicio/stop (start/stop)
Mains plug plugged in?
indicator light does not come on.
Programme selected?
The depósito (container)
Empty the condensation container
limp.
/
(clean) indicator light
comes on.
The depósito (container)
Clean the fluff filter
page 4.
limp.
/
(clean) indicator light
Clean the air cooler if necessary
page 6.
is flashing.
Dryer does not start.
Has the
inicio/stop (start/stop) button been pressed?
Drying time** in
Energy
Door closed?
minutes, includ-
consumption**
Programme set?
ing 8 minutes
in kWh
Programme stops shortly after it
Ambient temperature greater than 5 °C?
cool cycle
has started.
16 A
16 A
10 A
10 A
Water is leaking out.
Make sure the dryer is level.
98
90
3.32
3.32
The door opens by itself.
Push the door closed until you hear it engage.
The required degree of dryness
Clean the fluff filter
page 4.
117
106
3.92
3.92
was not achieved or the drying
Empty the condensation container.
120
138
4.48
4.48
time was too long.
Ambient temperature higher than 35 °C
76
66
2.45
2.45
Air inlet may be blocked
keep unobstructed.
91
82
2.94
2.94
Was an unsuitable programme selected?
106
96
3.43
3.43
Has the dryer been installed with sufficient space on all
sides? Ensure that air can circulate.
Mains failure
Restart the dryer.
42
40
1.16
1.16
Thin layer of limescale on the moisture sensors. Clean the
moisture sensors
page 6.
53
45
1.45
1.45
Laundry damp.
Use the next drying programme up or use the timer
programme as a supplement
page 7.
Warm laundry feels damper than it really is!
The humidity in the room
Make sure the room is sufficiently ventilated.
has increased significantly.
Air inlet blocked?
keep unobstructed.
Ensure that the air cooler is in use.
One or more indicator lights is/are
Clean the air fluff filter and air cooler if necessary
flashing.
page 4/6.
Check the installation conditions
page 8.
Switch off, allow to cool, switch on again and restart the
programme.
Mains failure.
Remove laundry from the dryer immediately and spread
out. This allows the heat to dissipate.
If you cannot rectify a fault yourself or a repair is necessary:
– Set the programme selector to stop (Off).
– Remove the appliance plug from the socket.
– Call the after-sales service
after-sales service directory.
9
Safety instructions
– Pull the appliance plug out of the socket immediately or disconnect the fuse.
Emergency
ONLY use the
– In rooms inside the house.
dryer...
– To dry fabrics.
The dryer must
– Be used for other purposes than those described above.
NEVER...
– Be modified in terms of its technology or attributes.
Dangers
– The dryer must not be used by children or persons who have not been
instructed in its use.
– Do not leave children unsupervised near the dryer.
page 4.
– Keep pets away from the dryer.
– Remove all objects from pockets.
Make especially sure that cigarette lighters are removed as they constitute an
explosion hazard.
– Do not lean or sit on the door
risk of tipping.
– Open the door carefully. Hot steam may escape.
Installation
– Secure loose cables
tripping hazard.
– Do not operate the dryer if there is a risk of frost.
Mains
– Connect the dryer according to specifications to an AC earthed socket, as
connection
otherwise it cannot be guaranteed that the appliance is completely safe.
– The cable cross-section must be sufficient.
– Only use earth-leakage circuit breakers with the following symbol:
– The appliance plug and socket must be compatible.
– Do not use multiple plugs/couplings and/or extension cables.
– Do not touch or hold the appliance plug with wet hands
risk of electric shock.
– Never pull the appliance plug out of the socket by its cable.
airing.
– Do not damage the mains lead
risk of electric shock.
Operation
– Only load the drum with laundry.
page 7.
Check the contents before you switch the dryer on.
– Do not use the dryer if the laundry has been in contact with solvents, oil, wax,
grease or paint (e.g. hair setting spray, nail polish remover, stain remover,
cleaning solvent, etc.)
fire/explosion hazard.
– Dust (e.g. coal dust, flour) poses a danger:
do not use the dryer
explosion hazard.
– Do not put laundry containing foamed material/rubber in the dryer
elastic
material may be destroyed and the dryer may be damaged due to possible
deformation of the foamed material.
– Switch off the dryer once the programme has ended.
– Condensation is not drinking water and may be contaminated with fluff.
Defect
– Do not use the dryer if it is defective or if you suspect it is.
Repairs must only be carried out by the after-sales service.
– Do not use the dryer if the mains cable is defective. To avoid danger, only
have the defective mains cable replaced by the after-sales service.
Spare parts
– Only use genuine spare parts and accessories for safety reasons.
Disposal
– Dryer: pull out the appliance plug, then cut off the mains cable from the
appliance. Dispose of the appliance at a municipal waste disposal facility.
– Packaging: do not leave children alone with packing parts
risk of suffocation.
– All materials are environmentally safe and can be reused. Dispose of all
materials in an environmentally-responsible manner.
10
Read these instructions before operating the dryer.
en
Instructions for
installation and use
Tumble dryer
Observe the safety instructions on page 11.
11
Advertisement
Table of Contents
