Siemens RUGGEDCOM ROS v5.0 User Manual page 43

RUGGEDCOM ROS
User Guide
Command
clearlogs
clrcblstats [ all |
port ]
clrstpstats
cls
dir
exit
factory
flashfiles { info
filename | defrag }
flashleds
timeout
fpgacmd
help
command
ipconfig
loaddflts
logout
logs
Available CLI Commands
Description
• port is a comma separated list of port numbers (e.g. 1,3-5,7)
Clears the system and crash logs.
Clears cable diagnostics statistics for one or more ports.
Optional and/or required parameters include:
• all clears statistics for all ports
• port is a comma separated list of port numbers (e.g. 1,3-5,7)
Clears all spanning tree statistics.
Clears the screen.
Prints the directory listing.
Terminates the session.
Enables factory mode, which includes several factory-level
commands used for testing and troubleshooting. Only available to
admin users.
CAUTION!
Misuse of the factory commands may corrupt the
operational state of device and/or may permanently
damage the ability to recover the device without
manufacturer intervention.
A set of diagnostic commands to display information about the Flash
filesystem and to defragment Flash memory.
Optional and/or required parameters include:
• info filename displays information about the specified file in
the Flash file system
• defrag defragments files in the Flash file system
For more information about the flashfiles command, refer to
Section 2.7, "Managing the Flash File System"
Flashes the LED indicators on the device for a specified number of
seconds.
Optional and/or required parameters include:
• timeout is the number of seconds to flash the LED indicators.
To stop the LEDs from flashing, set the timeout period to 0 (zero).
Provides access to the FPGA management tool for troubleshooting
time synchronization.
Displays a brief description of the specified command. If no
command is specified, it displays a list of all available commands,
including a description for each.
Optional and/or required parameters include:
• command is the command name.
Displays the current IP address, subnet mask and default gateway.
This command provides the only way of determining these values
when DHCP is used.
Loads the factory default configuration.
Logs out of the shell.
Displays syslog entries in CLI shell.
Authorized Users
Admin
Admin
Operator, Admin
Guest, Operator, Admin
Guest, Operator, Admin
Guest, Operator, Admin
Admin
Admin
.
Admin
Admin
Guest, Operator, Admin
Guest, Operator, Admin
Admin
Guest, Operator, Admin
Admin
Chapter 2
Using ROS
31