Apex Digital CRYSTAL Quick Start Manual

CRYSTAL, CLASSIC, TOUCH PRO
THERMOSTATIC SWITCH
PRODUCT INTRODUCTION
an advanced, intelligent device designed for
seamless remote control via the Z-Wave 800 LR
Series network. Compatible with any standard Z-
Wave gateway, the APEX keypad integrates
effortlessly into your smart home system. Featuring
four touch-sensitive buttons, each capable of two
actions (long press and short press), the APEX offers
versatile control options. The RGB backlight allows
for customizable status colors for each button, and
icons can be easily swapped by the dealer without
the need for specialized equipment on Crystal
series. Experience unparalleled convenience and
customization with the APEX Smart Thermostatic
Keypad.
WWW.SMARTAPEX.ES
SPECIFICATIONS
Model number APX-(Crystal, Classic, Touch pro)
Power requirement 100 to 240VAC / DC24V /AC+0-10V
Power consumption <1W
Frequency 868.4MHz EU (optional)
Z-wave Series 800 LR
-10 to +70 ̊ C
Operational
temperature
Humidity 5% to 90% non-condensing
Weight 0.2 kg
Material Glass / Aluminum
Standard Size 86x86m EU size
1.5A per inductive output
Fan Load (coils current)
ADD TO Z-WAVE NETWORK
1. Connect to Power: Ensure the device is connected
to a power source.
2. Check LED Status: Confirm that the LED status lights
are steady.
3. Initiate Pairing: Touch and hold the first button for 4
seconds. The blue LED indicators will start blinking.
Ensure your Z-Wave gateway is in identification
mode.
4. Complete Joining: When the device enters
identification mode, the blinking color changes to
green. Wait for the process to complete, indicated
by all LED lights becoming steady.
REMOVE FROM Z-WAVE NETWORK
1- Ensure Device is Powered: Confirm the device is
connected to a power source.
2- Set Gateway to Exclusion Mode: Put your Z-
Wave gateway into exclusion mode (refer to
your gateway's user manual).
3- Touch and hold the first button for 12 seconds
until the red LED lights start blinking. If the
gateway is in exclusion mode, the device will be
removed from the network.
RESET TO FACTORY SETTING (Network reset)
1- Initiate Reset: Touch and hold the first button
for 12 seconds until the red LED lights start
blinking, then release the button.
2-
Complete Reset: Immediately press and hold
the first button again for another 12 seconds.
The device will restart and reset to factory
settings.
QUICK REFERENCE
Buttons Description
Thermostat on/off button
WHILE THERMOSTAT IS ON:
LONG PRESS FOR 3 SEC: change mode (cool,
heat, fan)
WHILE THERMOSTAT IS OFF:
LONG PRESS FOR 3SEC: active or deactivate
temperature display on OFF mode
Increase or decrees temperature set point
Fan coil speed control: low, medium, high or
Auto
LONG PRESS FOR 5SEC: enable or disable
temperature display LOCK
SERVICE
Your Thermostatic keypad switch carries a
24-month warranty from the date of Installation.