Timer Operations - Aiwa XR-EC10 Operating Instructions Manual

TIMER OPERATIONS

POWER
6STANDBY/ON
En
SET
Setting the clock
1 Hold down SHIFT and press CLOCK on the remote
control.
When the unit is turned off, you can also press SET.
2 Within 6 seconds, press f or g to set the
time.
Each press changes the time in 1-minute steps.
Holding these buttons down will vary the time in 10-minute
units.
3 Press SET.
The time display stops flashing and the clock starts from
00 seconds.
12
POWER
VOLUME
CLOCK
s
ECD
DISC DIRECT
PLAY
f,g
SET
DISC DIRECT
TIMER
PLAY
SHIFT
TUNER/
BAND,AUX
To display the time while the power is on
Hold down SHIFT and press CLOCK on the remote control.
The time will be displayed for 6 seconds.
To switch to the 24-hour standard
Display the time and press s within 6 seconds.
With each press, the clock alternates between 12- and 24-
hour standard time.
Tip:
In the 12-hour standard, "AM12:00" indicates midnight and
"PM12:00" noon.
If the clock display flashes when the unit is turned
off
There has been a power interruption. Reset the clock.
Sleep timer
Turns off the unit automatically after a specified time.
1 Press SLEEP on the remote control.
"SLEEP" is displayed.
TUNER/BAND, 2 Within 6 seconds, press f or g repeatedly
AUX, ECD,
to set the sleep timer duration.
s
With each press, the timer duration changes in 5-minute
f,g
steps between 5 to 240 minutes. If there is no button input
for 6 seconds, the current setting is entered automatically.
VOLUME+/-
The unit turns off after the selected time.
SLEEP
To check the remaining time until the unit turns off
Press SLEEP on the remote control. The remaining time is
displayed for 6 seconds.
To cancel the sleep timer
Press SLEEP on the remote control repeatedly so that "SLEEP
oFF" is displayed.