GE Profile DPSE810EG0WT Owner's Manual page 9

About the control settings.
IMPORTANT: Clean the lint filter each time you use the dryer.
Temperature
HIGH HEAT For regular to heavy cottons.
MEDIUM HEAT For synthetics, blends, delicates and items labeled permanent press.
NO HEAT For fluffing items without heat. For use only with the TIMEDDRY cycles.
LOW HEAT For delicates, synthetics and items labeled tumble drLl low.
e
Wrinkle Care
Use this option to minimize the wrinkles in clothes. It provides approximately 15 minutes of no-heat tumbling after the
clothes are dry.
This option can only be used with the COTTONS, EASY CARE and DELICATEScycles. If you are using CYCLESIGNAL
and you select the WRINKLE CARE option, a signal will sound at the end of the drying time and several times during
the WRINKLE CARE cycle. This will remind you that it is time to remove the clothes.
If WRINKLE CARE is not ON, the dryer will stop once the timer reaches the WRINKLE CARE mark on the cycle dial
Drying
Cycles--Automatic cycles automatically dryness, you want your
determine fabric Select LESS DRY if
clothes slightly damp at the end of the drying cycle. Select MORE DRY if you want them to feel drier. Timed cycles
run for the selected time,
COTTONS
EASY CARE
DELICATES
TIMED DRY
DAMP DRY
DEWRINKLE
QUICK FLUFF
For cottons and most linens. For most loads, select OPTIMUMDRY
For wrinkle-free, permanent press and delicate items, and knits.
For delicate items, special-care fabrics and knits.
Set the Cycle Selector at the desired drying time.
For leaving items partially damp.
For removing wrinkles from items that are clean and dry or that are very lightly damp.
For freshening or fluffing up already dry clothing, fabric, linens and pillows. Use with NO HEAT.
Provides 10 minutes of no-heat tumbling.
_I_ dryer Press START. O pening during operation stop dryeE To restart
START--Close the dooE the door
will
the the
dryer, close the door and press STARTto complete the cycle.
NOTE: Drying times will vary according to the type of heat used (Electric, Natural or LP gas), size of load, types
of fabrics, wetness of clothes and condition of exhaust ducts.