Changing The Presser Foot - Singer 6233 Manual

Changing thePrcsserFoot (B) (E) (J) (L)
Your machine comes with the General Purpose Presser Foot already attached. You can easily
change to any one of the other presser feet which snap onto a common shank by following the
directions below.
. Raise needle to its highest position by
turning hand wheel toward you.
. Raise presser foot using presser foot lifter
in back ol machine.
r Push toe of presser foot (1) up, until it
snaps otf the shank (2).
. Take foot otf machine.
. Place new foot under center of shank.
r Lower presser foot lifter, fitting shank over
presser fool pin (3).
r Don't turn screw. Instead, push presser
foot screw (4) down firmly until foot snaps
into place.
o Raise needle and presser foot.
o Open slide plate.
o Slide feed cover on top of needle plate,
pressing tabs (1) and (2) into holes.
o Close slide plate.
o To remove, open slide plate and litt
front edge of cover; pull it away.
ATTACH,NC FEED COVEN G)
The feed cover keeps the feed lrom moving the fabric.