Download Print this page

AEG AGB332E2NW User Manual page 16

Advertisement

16
www.aeg.com
Problem
Water flows on the floor.
Temperature cannot be set.
The temperature in the appli‐
ance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.
Possible cause
Temperature is set incorrect‐
ly.
Appliance is fully loaded and
is set to the lowest tempera‐
ture.
Temperature set in the appli‐
ance is too low and the am‐
bient temperature is too
high.
The melting water outlet is
not connected to the evapo‐
rative tray above the com‐
pressor.
The Super Freeze function is
switched on.
The temperature is not set
correctly.
The door is not closed cor‐
rectly.
The food products' tempera‐
ture is too high.
Many food products are stor‐
ed at the same time.
The door has been opened
often.
The Super Freeze function is
switched on.
There is no cold air circula‐
tion in the appliance.
8.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to the "Installation" chapter.
Solution
Refer to the "Operation"
chapter.
Set a higher temperature.
Refer to the "Operation"
chapter.
Set a higher temperature.
Refer to the "Operation"
chapter.
Attach the melting water out‐
let to the evaporative tray.
Switch off the Super Freeze
function manually, or wait
until the function deactivates
automatically to set the tem‐
perature. Refer to the "Super
Freeze function" section.
Set a higher/lower tempera‐
ture.
Refer to the "Closing the
door" section.
Let the food products tem‐
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces‐
sary.
Refer to the "Super Freeze
function" section.
Make sure that there is cold
air circulation in the appli‐
ance. Refer to the "Hints and
tips" chapter.

Advertisement

loading
Need help?

Need help?

Do you have a question about the AGB332E2NW and is the answer not in the manual?