Related Manuals for ITC VA-6000BC
Summary of Contents for ITC VA-6000BC
- Page 1 ITC VOICE ALARM AND EVACUATION SYSTEM VA-6000BC USER MANUAL Thank you for purchasing EVAC System. Please carefully follow the instructions in this manual to ensure long, trouble-free use of your equipment. 2 Product introduction...
- Page 2 1. Worship reader Thank you for use ITC EVAC System, for your better understanding please follow the below information: 1.1 Voice massages referred in the User manual include: ■ Build-in EVAC, ALERT Massages ■ Build-in Paging and PSTN chime ■ Build-in BGM, AUDIO INPUT and Paging Audio Notice: The voice message storage of the 4 SD cards EVAC/ ALERT/ BGM/ PROMPT should not be more than 100.
- Page 3 —There is fault from the equipment or module detected by the system. —It means the system is working in the emergency mode. —It means the controller is off-line. —It means the network is connected. —It means the current controller is starting PSTN paging function. —It means there is mic paging.
- Page 4 two machine for heat dissipation. ■ Make sure all the machines are earthed. ■ Parallel connection are not allowed between amplifiers, prevent the amplifiers from terminal fault. ■ Remote MIC VA-6000FM/ RM offer phantom power and real-time detection. Do not turn off switch when system is working, in case of the wrong detection.
- Page 5 3. DC Power Supply and Battery Charger——VA-6000BC VA-6000BC is mainly used in VA-6000 system to provide stable and reliable spare DC power when there is no AC power supply. Electrical is in Storage battery with maintenance –free which adopts two DC 24V lead-acid batteries or one DC 24V lead-acid battery, Build-in battery charge management and monitoring circuit.
- Page 6 4. Charging status indicator light: Off - Battery has been filled. Green - Charger is charging the storage battery. 5. Charging status indicator light: Off - Voltage normal. Yellow - Over voltage, charging will be stopped automatically to protect the storage battery. (When the voltage reaches for 30V in the charging process, the charger will stop to work and the V-high lights up.) 6.
- Page 7 7. Communication address,"1, 2" is communication address bit, the largest address is 3, if there is only one charger, pull off “1,2” address bit "3" means standalone working mode, please make it on when charger is not used in VA-6000 system, otherwise the charger cannot work normally; address bits "4, 5"...
- Page 8 4. Operating instructions 4.1 Connection diagram of DC electrical source& Battery charger is as following: Remarks: The reference list of wire selection. Wire Gage CSA( Cross-secti Environment Environment Environment onal area) of conductor temperature temperature of temperature of Conductor resistance of maximum maximum maximum...
- Page 9 4.2 Charging graph of the charger In order to protect the accumulator, select the appropriate electric current with the position selective switch on the rear panel, based on the capacity of the accumulator. In the pre-charging status, when the voltage reaches for 21.5V or above in 3 minutes, the charger will get into constant-current charging status.
- Page 10 5. Common problems and solutions Symptom of failure Solutions ①Check if the battery cable is well connected. ②Check if the voltage detection cable linked to storage battery is well connected. The indicator of connection status of storage battery lights ③Check if temperature sensor cable is well connected or if the in yellow color.
- Page 11 Version:V0.4 - 10 -...
Need help?
Do you have a question about the VA-6000BC and is the answer not in the manual?
Questions and answers