Download Print this page

TigerTough E0822052 Manual

Single seat cover

Advertisement

Quick Links

Hey there!
It's not rocket science, but following the instructions will make installing your
seat covers a lot easier. We promise.
If you have any questions, comments, or issues, we're here to help! You can
reach us at 507.246.3545 (call or text) or email orders@tigertough.com.
PART NUMBER
PRODUCT TYPE
E0822052
SINGLE SEAT COVER
(1) SEAT BACK
PIECES
(1) SEAT BOTTOM
(1) HEADREST
(1) STRINGLOCK

Advertisement

loading
Need help?

Need help?

Do you have a question about the E0822052 and is the answer not in the manual?

Questions and answers

Summary of Contents for TigerTough E0822052

  • Page 1 It’s not rocket science, but following the instructions will make installing your seat covers a lot easier. We promise. If you have any questions, comments, or issues, we’re here to help! You can reach us at 507.246.3545 (call or text) or email orders@tigertough.com. PART NUMBER E0822052...
  • Page 2 LIFETIME WARRANTY Basically, you break it, we buy it. Seriously. Your new seat covers are covered by an unconditional, no B.S. warranty. That means that if you manage to abuse them to a point that they can’t perform like they’re supposed to, we’ll make it right. Depending on what is more practical, we’ll either repair or replace the damaged cover.
  • Page 3 Install Seat Cover page 1 Remove the headrest. Just like with the headrest mounts, Pull the plastic tab work the cover around towards the front and the plastic edge of the lift the headrest all of knob and switch. the way up and off. Turn the cover Push the flaps in halfway inside out.
  • Page 4 Install Seat Cover page 2 Push the tabs in Secure the flap up between the back and inside the back of the bottom. headrest cover. Pull tight and secure You’re finished! behind seat. Run both strings to the back of the seat. The string by the seat belt retracter goes under it as shown.
  • Page 5 THE STRINGLOCK Run one string through the channel on the end of the StringLock. Pull the string tight, pulling the StringLock towards one edge of the seat. Press the string into the clamp, locking it in place. Run the second string through the StringLock just like the other one.