TigerTough 182103 Installation Manual

For tesla model y/model 3

182103 - Bucket Set

Table of Contents

Need help?

Do you have a question about the 182103 and is the answer not in the manual?

Page 1 182103 - Bucket Set...
Page 2 INSTALLATION GUIDE 182103 Bucket Set Tesla Model Y/Model 3...
Page 3 Passenger Seat Back Cover Headrest Cover Seat Backs & Bottoms have tags signifying Driver or Passenger. Ensure airbag patch (same side as the TigerTough tag) goes on the outside edge of the seat. Watch the installation video at ttcovers.com/182103 General care instructions: 1.
Page 4 Basically, you break it, we buy it. Seriously. Your new seat covers are covered by a two-year, unconditional, no B.S. warranty. That means that if you manage to abuse them to a point that they can’t perform like they’re supposed to within two years of when you bought them, we’ll make it right.
Page 5 Install Seat Bottom Cover Slide the seat Drop the string forward and raising closest to the it to the highest door between the position to give you plastic trim and the most amount of the seat cushion working room. to run it on the inside of the seat From behind the frame.
Page 6 THE STRINGLOCK Run one string through the channel on the end of the StringLock. Pull the string tight, pulling the StringLock towards one edge of the seat. Press the string into the clamp, locking it in place. Run the second string through the StringLock just like the other one.
Page 7 Install Seat Back Cover Undo the flap on Fasten the top of the seat back wide flap from cover. Turn cover the seat back 3/4 inside out, work cover around to cover over headrest the seat bottom and down the seat cover.

182103blk