1. Manuals
  2. Brands
  3. TigerTough Manuals
  4. Automobile Accessories
  5. T62213
  6. Installation manual

TigerTough T62213 Installation Manual

Tactical driver's seat cover
Hide thumbs

Advertisement

Table of Contents

T62213 Tactical Driver's Seat Cover

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the T62213 and is the answer not in the manual?

Questions and answers

Related Manuals for TigerTough T62213

Summary of Contents for TigerTough T62213

  • Page 1 T62213 Tactical Driver’s Seat Cover...
  • Page 2 Basically, you break it, we buy it. Seriously. Your new seat covers are covered by a two-year, unconditional, no B.S. warranty. That means that if you manage to abuse them to a point that they can’t perform like they’re supposed to within two years of when you bought them, we’ll make it right.
  • Page 3 INSTALLATION GUIDE T62213 Tactical Driver’s Seat Cover Chevrolet Tahoe SSV/PPV (2021-2022)
  • Page 4 Driver Seat Back Cover Driver Seat Bottom Cover Seat Headrest Cover Ensure airbag patch (same side as the TigerTough tag) goes on the outside edge of the seat. General care instructions: 1. In most cases dirt, debris, spills and pet hair can be removed by wiping with a damp cloth.
  • Page 5 1 - Install Seat Back Cover q 1.1 - Unhook both elastic straps from under the seat bottom to release the seat back flap. q 1.2 - Lean seat back forward. q 1.3 - Turn seat back cover 3/4 of the way inside out and pull over seat back. q 1.4 - Work cover over the headrest.
  • Page 6 2 - Install Seat Bottom Cover Seat cover string between seat bottom and plastic trim, where back and bottom meet. q 2.1 - Put cover over seat bottom. q 2.2 - Tuck cover behind plastic trim around seat. The seams in the cover will line up with seat seams. q 2.3 - Tuck outside string between seat bottom and trim, where the back and bottom meet.
  • Page 7 THE STRINGLOCK Run one string through the channel on the end of the StringLock. Pull the string tight, pulling the StringLock towards one edge of the seat. Press the string into the clamp, locking it in place. Run the second string through the StringLock just like the other one.
  • Page 8 3 - Install Headrest Cover q 3.1 - Put headrest back in seat by pressing it back into place. q 3.2 - Pull cover over head rest with “loop” Velcro in front and “hook” Velcro in rear. q 3.3 - Fasten Velcro tabs together under headrest. q 3.4 - Tuck cover behind plastic trim around button.

Table of Contents