Related Manuals for Avigilon AINVR2-STD-FORM-D-PRK
Summary of Contents for Avigilon AINVR2-STD-FORM-D-PRK
- Page 1 AI NVR 2 Standard Form D Performance Kit Installation Guide AINVR2-STD-FORM-D-PRK AI NVR 2 Standard Form D...
- Page 2 Avigilon Corporation nor any of its affiliated companies: (1) guarantees the completeness or accuracy of the information contained in this document; or (2) is responsible for your use of, or reliance on, the information. Avigilon Corporation shall not be responsible for any losses or damages (including consequential damages) caused by reliance on the information presented herein.
- Page 3 Contents Introduction Confirm Package Contents Required Tools Installing the AI NVR 2 Standard Form D Performance Kit Opening the Cover Installing the CPU Installing Additional RAM Installing the New Graphics card Reattaching the Cover Confirming the Installation For More Information Additional Documentation...
- Page 4 Introduction Avigilon provides an optional AI NVR 2 Performance Upgrade Kit for the AI NVR 2 Standard Form D. This kit increases the analytic capacity of the AI NVR 2 Standard Form D allowing it to run more concurrent analytics. See Analytics Sizing Guide for more details.
- Page 5 Confirm Package Contents Confirm that the kit you are installing contains the following components: 1 × Intel Xeon Gold 5415+ CPU 1 × processor bracket 1 × heat sink 2 × 16GB RDIMM 1 × T1000 graphics card Required Tools The following tools are not included in the kit package, but are needed to complete the installation: Phillips #2 screwdriver IMPORTANT...
- Page 6 Installing the AI NVR 2 Standard Form D Performance Kit Before starting to install the kit: 1. Log in to the ACC Client on a workstation on the same network as the AI NVR 2Standard Form D you are going to upgrade. a.
- Page 7 Opening the Cover 1. At the top of the AI NVR 2 Standard Form D, unlock the latch release then lift and rotate the latch towards the back of the unit. The cover slides back and is released from the body. Use a Phillips #2 screwdriver to remove the shipping screws before unlatching the cover if you are removing the cover of an AI NVR 2 Standard Form D for the first time.
- Page 8 Installing the CPU You need the processor bracket, processor (CPU), and heatsink provided in the kit to complete this procedure. With the AI NVR 2 Standard Form D open and the protective cover removed: 1. Locate the 2 processor socket on the AI NVR 2 Standard Form D's system board and pull off the CPU dust cover with the yellow label over the socket.
- Page 9 7. Align the pin 1 indicator on the heat sink to the system board and then place the processor and heat sink module on the processor socket. IMPORTANT Ensure that the processor and heat sink module is held parallel to the system board to prevent damaging the components.
- Page 10 IMPORTANT Do not force the processor into the socket. The processor should slide easily into the socket when aligned correctly. 9. Use the star-shaped screwdriver #T30 to tighten the screws on the heat sink in the following order: a. Partially tighten the first screw (approximately 3 turns). b.
- Page 11 Installing Additional RAM IMPORTANT To prevent damage to the DIMM or memory module socket during installation: Do not bend or flex the DIMM. Handle each DIMM only by the edges to ensure that you don't touch the middle of the memory module or the metallic contacts.
- Page 12 inserted into the sockets. 3. Align the edge connector of the DIMMs with the alignment key of the sockets and press the DIMMs into sockets until the socket levers click into place. Installing the New Graphics card 1. Unpack the graphics card and prepare it for installation. NOTE For instructions, see the documentation accompanying the card.
- Page 13 Confirming the Installation Verify the upgrade is successful: 1. Log in to the ACC Client on a workstation on the same network as the AI NVR 2 Standard Form D. 2. In the System Explorer, click Site Setup, and click Site to expand the site containing the upgraded AI NVR 2 Standard Form D.
- Page 14 For More Information For additional product documentation and software and firmware upgrades, visit support.avigilon.com. Technical Support Contact Avigilon Technical Support at support.avigilon.com/s/contactsupport. Additional Documentation AI NVR 2 User Guides Windows Upgrade and Recovery Guide for Avigilon Enabling iDRAC Enterprise Features Setup Guide...
Need help?
Do you have a question about the AINVR2-STD-FORM-D-PRK and is the answer not in the manual?
Questions and answers