Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Avigilon AI NVR Standard Performance Kit
Summary of Contents for Avigilon AI NVR Standard Performance Kit
- Page 1 AI NVR Standard Performance Installation Guide AINVR-STD-PRK AINVR-STD ...
- Page 2 © 2021, Avigilon Corporation. All rights reserved. AVIGILON, the AVIGILON logo, AVIGILON are trademarks of Avigilon Corporation. Intel is a trademark of Intel Corporation or its subsidiaries in the U.S. and/or other countries. Other names or logos mentioned herein may be the trademarks of their respective owners. The absence of the symbols ™...
-
Page 3: Table Of Contents
Table of Contents Introduction Confirm Package Contents Required Tools Installing the AI NVR Standard Performance Kit 1. Removing the AI NVR Cover 2. Installing the CPU 3. Installing Additional RAM 4. Installing the New GPU card 5. Restoring the Removed Components 6. Confirming the Installation For More Information... -
Page 4: Introduction
Introduction Avigilon provides an optional AI NVR Performance Upgrade Kit for the AI NVR Standard. This kit increases the analytic capacity of the AI NVR allowing it to run more concurrent analytics. See the Analytics Sizing Guide for more details. Important: An AI NVR Standard with the Performance Upgrade Kit installed is supported on Release ACC 7.12.4 or... -
Page 5: Installing The Ai Nvr Standard Performance Kit
Installing the AI NVR Standard Performance Kit Before starting to install the kit: 1. Log in to the ACC Client on a workstation on the same network as the AI NVR you are going to upgrade. a. In the System Explorer, select the AI NVR you are going to upgrade. b. -
Page 6: Removing The Ai Nvr Cover
1. Removing the AI NVR Cover 1. Shut down the AI NVR. Press the power button on the front panel, and wait for the light to stop blinking to indicate shutdown is complete. 2. Remove all network, power and peripheral cables from the AI NVR. 3. -
Page 7: Installing The Cpu
Card RIser 1 Slot 1 (labeled 10 in the diagram). Do not remove this card as part of this upgrade. The components affected by the AI NVR Standard Performance Upgrade Kit are: 4— Memory module The 2 DIMMs in the upgrade kit are installed here. ... - Page 8 procedure. With the AI NVR open and the protective cover removed: 1. Locate the 2nd processor socket and pull off the CPU dust cover with the yellow label over the socket. 2. Unpack the CPU. 3. Place the processor in the processor tray. Note: Ensure that the pin 1 indicator on the processor tray is aligned with the pin 1 indicator on the processor.
- Page 9 7. Align the pin 1 indicator on the heat sink to the system board and then place the processor and heat sink module on the processor socket. Important: Ensure that the processor and heat sink module is held parallel to the system board to prevent damaging the components.
-
Page 10: Installing Additional Ram
Important: Do not force the processor into the socket. The processor should slide easily into the socket when aligned correctly. 9. Use the star-shaped screwdriver #T30 to tighten the screws on the heat sink in the following order: a. Partially tighten the first screw (approximately 3 turns). b. - Page 11 Important: To prevent damage to the memory module or memory module socket during installation, do not bend or flex the memory module. You must insert both ends of the memory module simultaneously. 1. In the row of empty memory sockets near to the newly installed CPU, locate sockets B1 and B2. 2.
-
Page 12: Installing The New Gpu Card
4. Installing the New GPU card 1. Unpack the GPU card and prepare it for installation. Note: For instructions, see the documentation accompanying the card. 2. At the back of the AI NVR, locate where the GPU card needs to be installed. 3. Pull the expansion card latch. 4. -
Page 13: Restoring The Removed Components
7. Insert the GPU card edge connector firmly into the expansion card connector until the card is fully seated. 8. Push the expansion card latch. 5. Restoring the Removed Components When all the components of the kit have been installed: 1. - Page 14 c. The number of connected cameras should be the same as before the AI NVR was upgraded, and the analytics load should be about half of what it was prior to the upgrade. Limited Warranty Avigilon warranty terms for this product are provided at avigilon.com/warranty. 6. Confirming the Installation...
-
Page 15: For More Information
For More Information For additional product documentation and software and firmware upgrades, visit avigilon.com/support. Technical Support Contact Avigilon Technical Support at avigilon.com/contact. For More Information...
Need help?
Do you have a question about the AI NVR Standard Performance Kit and is the answer not in the manual?
Questions and answers