Advertisement
Quick Links
Variable Speed Pumps
Instruction Manual
SHP130-VS
SFP220-VS
SWP390-VS
READ CAREFULLY AND FOLLOW
THIS INSTRUCTION
KEEP THIS INSTRUCTION FOR
FUTURE REFERENCE
SHP130-VS, SFP220-VS, SWP390-VS Variable Speed Pumps Instruction
For more details and video, please visit www.lingxiao.com.cn
Advertisement
Related Manuals for LX SHP130-VS
Summary of Contents for LX SHP130-VS
- Page 1 Variable Speed Pumps Instruction Manual SHP130-VS SFP220-VS SWP390-VS READ CAREFULLY AND FOLLOW THIS INSTRUCTION KEEP THIS INSTRUCTION FOR FUTURE REFERENCE SHP130-VS, SFP220-VS, SWP390-VS Variable Speed Pumps Instruction For more details and video, please visit www.lingxiao.com.cn...
- Page 2 TABLE OF CONTENTS Important Warning and Safety Instructions ----------------------------- 1~2 Overview ------------------------------------------------------------------------------- 3 Pump Features Drive Overview Keypad Overview -------------------------------------------------------------------- 4 Installation ----------------------------------------------------------------------------- 5 Location Piping Fitting and Valves Electrical Installation Wiring Position ---------------------------------------------------------------------- 6 Wiring position Grounding Bonding External Control Via RS485 Signal Cable ----------------------------------- 7 RS485 signal cable connection Operation ------------------------------------------------------------------------------ 8 Setting the Clock...
- Page 3 • Avoid getting close to any suction cover, pool drain, or outlet with your hair, limbs, or body. • Suction outlets can be disabled or reset into return inlets SHP130-VS, SFP220-VS, SWP390-VS Variable Speed Pumps Instruction For more details and video, please visit www.lingxiao.com.cn...
- Page 4 IMPORTANT: If the filter pressure gauge is higher than the pre-service condition, don't close the manual air relief valve until all pressure has been released from the valve and a steady stream of water appears. SHP130-VS, SFP220-VS, SWP390-VS Variable Speed Pumps Instruction For more details and video, please visit www.lingxiao.com.cn...
- Page 5 • ANSI standard fittings (1.5” OR 2”). • Quick & easy operation for In ground Self-priming pumps (SFP220-VS Pump is rated for 115/208-230 Volts nominal, Only for & SWP390-VS) & above ground swimming pool pump (SHP130-VS). DANGER pool pumps. Connecting incorrect voltage or use in •...
- Page 6 3 seconds at the same time to lock/unlock the keyboard. Key combination The controller displays the home page, press the button for 3 seconds at the same time to turn on/off the button sound. SHP130-VS, SFP220-VS, SWP390-VS Variable Speed Pumps Instruction For more details and video, please visit www.lingxiao.com.cn...
- Page 7 (5) times of suction line diameter from the discharge port. For example, 2” pipe requires 10” straight line before the suction port of the pump, as below drawing. 5 times of suction line diameter SHP130-VS, SFP220-VS, SWP390-VS Variable Speed Pumps Instruction For more details and video, please visit www.lingxiao.com.cn...
- Page 8 (Neutral Wire), Terminal (Ground the motor. wire). This applies to SHP130-VS & SFP220-VS. 2. Input power MUST match the requirements on the data plate. 3. Regarding wiring sizes and general requirements, it is important to follow the specifications as defined by the current National Electric Code and any local codes.
- Page 9 3. After successfully connected, the monitor of pump will show ECOM and the Communication indicator will be lighted up. Then, the pump gives the control right to Pentair Control System. SHP130-VS, SFP220-VS, SWP390-VS Variable Speed Pumps Instruction For more details and video, please visit www.lingxiao.com.cn...
- Page 10 Use button to set minute. speed 3450 RPM. For Non self-priming above ground pool pump (SHP130-VS), the factory default setting is running the pump for 1 minute at maximum speed 3450 Programming an Operation Schedule: RPM to exhaust air inside the pipe line.
- Page 11 Note: In the case of a pump that is installed below the water line of a pool, ensure that the return and suction lines are closed before opening the strainer pot on the pump. Before operating, reopen valves. SHP130-VS, SFP220-VS, SWP390-VS Variable Speed Pumps Instruction For more details and video, please visit www.lingxiao.com.cn...
- Page 12 9. To bleed air from the filter air relief valve, open the valve and let the air escape until a steady stream of water appears. When the priming cycle is complete, the pump will begin normal operation. SHP130-VS, SFP220-VS, SWP390-VS Variable Speed Pumps Instruction For more details and video, please visit www.lingxiao.com.cn -10-...
- Page 13 E002 will automatically recover, and other fault codes will appear, the inverter will stop, and it needs to be powered off and on again to restart the inverter. SHP130-VS, SFP220-VS, SWP390-VS Variable Speed Pumps Instruction For more details and video, please visit www.lingxiao.com.cn...
- Page 14 Current Qmax Speed Hmax Model (Hz) (THP) (L/min) (r/min) (Kg) SHP130-VS 50/60 11.3 450~3450 13.8 SFP220-VS 50/60 450~3450 115/208-230 13.8/8.5-7.4 SWP390-VS 50/60 450~3450 25.8 SHP130-VS, SFP220-VS, SWP390-VS Variable Speed Pumps Instruction For more details and video, please visit www.lingxiao.com.cn -12-...
- Page 15 1 /- 11.5NPT l/min G 1 / m /h Flow SFP220-VS U . S.GPM IMP.GPM (psi) (ft) 35 25 l/min 17x11.5 m /h Flow SWP390-VS SHP130-VS, SFP220-VS, SWP390-VS Variable Speed Pumps Instruction For more details and video, please visit www.lingxiao.com.cn -13-...
- Page 16 IN ORDER TO AVOID DAMAGE DURING TRANSPORTATION. All indicated LX trademarks and logos are our property. Third parties own their registered and unregistered trademarks and logos. Since our products and services are continuously being improved, all rights are reserved to change specifications without prior notice.
Need help?
Do you have a question about the SHP130-VS and is the answer not in the manual?
Questions and answers