Page 2
Thank you for choosing a Hoover dish Contents washer. We are confident it will assist you loyally in washing your daily dishes in full safety. 1. GENERAL SAFETY RULES Carefully read this manual for correct and 2. WATER CONNECTION safe appliance use and for helpful tips on 3.
Page 3
1. GENERAL SAFETY capabilities or lack of experience and knowledge if they have been RULES given supervision or instruction This appliance is intended to l concerning use of the appliance be used in household and in a safe way and understand the similar applications such as: hazards involved.
Page 4
Make sure carpets or rugs do The manufacturer declines all l not obstruct the base or any of responsibility for any damage the ventilation openings. to people or property due to non-earthing of the machine. After installation, the appliance l must be positioned so that the Ensure that the dishwasher l...
Page 5
If there is a water softening l marking this product, device installed in the home we confirm, under our own there is no need to add salt to responsibility, full compliance the water softener fitted in the this product with dishwasher.
Page 6
2. WATER CONNECTION l If the dishwasher is connected to new pipes The appliance must be connected to or to pipes which have not been inuse for a the water mains using new hose-sets. long time run water through for a few The old hose-sets should not be minutes before connecting the inlet hose.
Page 7
l AQUASTOP (fig. 4): Hydraulic safety devices A device located on the supply tube that stops water flow if the tube deteriorates; in this case, a red mark will appear in the All the dishwashers are equipped with window "A" and the tube must be an overflow safety device which, if replaced.
Page 8
Connecting the outlet hose l The outlet hose should disharge into a l The hose can be hooked over the side of standpipe, making sure that there are no the sink, but it must not be immersed in kinks (fig. 6). water, in order to prevent water from being syphoned back to the machine l...
Page 9
3. LOADING THE SALT After loading the salt, YOU MUST run a complete washing cycle, or the (Fig. A "1") PRE-WASH/COLD RINSE/REFRESH programme. l The appearance of white stains on dishes is generally a warning sign that the salt container needs filling. l...
Page 10
4. ADJUSTING THE UPPER Type "B": (ONLY MODELS WITH EASY CLICK): BASKET (ONLY ON SOME 1. Remove the upper basket; 2. Hold the basket on both sides and lift it MODELS) upwards (fig. 1). l Dishes that are greater than 20 cm* in If 29 cm to 32.5 cm plates are regularly diameter can no longer be loaded onto the used, load them onto the lower basket...
Page 11
5. LOADING DISHES A standard daily load is represented in figs. 1 and 2. Using the upper basket l The upper basket is provided with mobile racks hooked to the sides of the basket, Upper basket (fig. 1) which can be regulated into 4 positions. l...
Page 12
l The lower basket is fitted with a special TOTAL CARE ACCESSORIES adjustable central rack (fig. 4 and 5). This (SOME MODELS ONLY) permits stable and optimum loading, even when the size and/or shape of the dishes Top basket with Total Care accessories is non-standard.
Page 13
Upper basket (fig. 6) The lower basket has a safety-stop device, for its safe extraction, also especially useful with a full load. For loading salt, cleaning filter and for ordinary maintenance, the complete extraction of the basket is necessary. Cutlery basket (fig. 8) The cutlery basket is made with two detachable parts which will enable various loading options.
Page 14
6. INFORMATION FOR WARNING TEST LABORATORIES The third basket is NOT designed for Please information required loading cutlery. The absence of racks for comparison testing and measuring noise fixing cutlery could involve such items levels, according to EN normative, to the being found in the lower baskets.
Page 15
7. LOADING THE DETERGENT (Fig. A "2") The detergent It is essential to use a detergent that is specifically designed for dishwashers either in powder, liquid,gel or tablet form. After pouring detergent into container, close the lid, firstly pushing (1) and then pressing on it (2) until you hear Unsuitable detergents...
Page 16
l 8. TYPES OF DETERGENT read carefully and follow the manufacturer’s instructions given on the packaging; Detergent tablets l the effectiveness of detergents containing the built in water softener/salt depends on Detergent tablets of different manufacturers the hardness of your water supply. Check dissolve at different speeds, for this reason, that the hardness of your water supply is during short programmes, some detergent...
Page 17
9. LOADING THE RINSE AID (Fig. A "3") The rinse aid The rinse aid, which is automatically released during the last rinsing cycle, helps the dishes to dry quickly and prevents spots and stains forming. Filling the rinse aid container. The rinse aid container can be found to the left of the detergent container (fig.
Page 18
10. CLEANING THE FILTERS (Fig. A "4") The filter system consists of: A. A central container that traps the larger particles; B. A micro filter, located beneath the gauze, that traps the tiniest particles ensuring a perfect rinse; C. A flat gauze that continuously filters the wash water.
Page 19
11. PRACTICAL HINTS to soften the food remains and remove bigger particles of food from the new load of dishes. When the dishwasher is full How to get really good wash start complete wash cycle results. programme. l Before placing dishes l...
Page 20
12. CLEANING AND Do not use tools that can deform the MAINTENANCE spray heads. (Fig. A “5”) 3) when you have finished, refit the rotor l To clean the dishwasher outside, do not arms same position, use solvents (degreasing action) neither remembering to re-align the arrow and abrasives, but only a cloth soaked with screw into position.
Page 21
If the machine is not going to be used for 4. fill the rinse aid container; some time, it is advisable to follow these 5. Ieave the door ajar; rules: 6. keep the inside of the machine clean; 1. do an empty wash with detergent in order to clean the machine of any 7.
Page 22
13. DESCRIPTION OF THE 14. TECHNICAL DATA CONTROL PANEL ...
Page 23
15. PROGRAMME SELECTION 10) "Total care" PROGRAMME INDICATOR LIGHT AND SPECIAL FEATURES When the Total Care programme is enabled, the corresponding indicator DISPLAY Description light comes on. 11) "HALF LOAD" OPTION INDICATOR The display keeps you constantly informed LIGHT on the operation of the appliance. 12) "EXTRADRY"...
Page 24
Settings Menu Changing language l From the settings menu, you can adapt Press the the OPEN DOOR various parameters to your washing needs. HALF LOAD buttons together for 5 seconds. Accessing the Settings Menu l “ENGLISH” appears on the display. l...
Page 25
When the door is shut, after an audible signal The cycle will start from where it left off. When has sounded, the programme will start the relating indicator light switches off, it is no automatically. The display will show the time longer advisable to add further dishes.
Page 26
If there is any break in the power supply Option buttons while the dishwasher is operating, a The option buttons provide you with further special memory stores the selected wash options, allowing you to customise the programme and, when the power is wash programmes (see the table in chapter restored, it continues from where it left off.
Page 27
"HALF LOAD" button (Only for free-standing models) If you need to wash just a few dishes (e.g. The length of the selected cycle will glasses, cups, plates), you can enabled the be shown on the display. At the end of "HALF LOAD"...
Page 28
Disabling "Demo mode" MEMO FUNCTION (Memorising the last programme used) WARNING 1. Hold the "Progr." button down and, at same time, switch Once installed, if the appliance works dishwasher using the "ON/OFF" button. correctly but the wash cycle does not start upon pressing the Start button, 2.
Page 29
Pairing the machine with the app l Only REMOTE CONTROL ON/OFF and START/RESET buttons will l Download the Hoover Wizard app onto remain enabled. your device. l It is now possible to manage the The Hoover Wizard app is available appliance via the app.
Page 30
Another way to exit remote control mode - FLASHING SLOWLY: remote control disabled. l Press the “START/RESET” button for 3 - FLASHING RAPIDLY FOR 3 SECONDS, seconds: any running cycle will be THEN OFF: the appliance is unable to cancelled, and the appliance will exit connect to the home Wi-Fi network or has REMOTE CONTROL mode.
Page 31
17. PROGRAMME LEGEND Programme Description Energy saving program intended for normal soiled loads of crockery, glassware and cutlery. Reference program as per AS/NZS 2007. Cycle with alternated action of water jets and steam. Effective in softening and removing dried STEAM up soil and bacteria, with no need to pre-wash pots and dishes.
Page 33
● = Detergent for soaking (Pre-wash) ■ = "IMPULSE" programmes ▲ = "AUTOMATIC" programmes ² N/A = OPTION NOT AVAILABLE 1) With cold water (15°C) – Tolerance ±10%- With hot water the time remaining until the end of the programme is automatically displayed while the programme is running.
Page 34
18. WATER SOFTENER UNIT Depending on the source of the supply, Regulate the setting of your water softener water contains varying amounts unit according to the degree of hardness of limestone and minerals which are deposited your water, as follows: on the dishes leaving whitish stains and marks.
Page 35
19. TROUBLESHOOTING AND WARRANTY If you believe the dishwasher is not working correctly, consult the quick guide provided below with some practical tips on how to fix the most common problems. If the malfunction continues or recurs, contact the Technical Assistance Centre. BUG REPORTS l...
Page 36
Only models without a display If malfunctions or faults occur when a programme is running, the indicator light that corresponds to the selected cycle will blink rapidly, and an intermittent audio signal will sound. In this case, turn the dishwasher off by pressing the "ON/OFF" button. After checking to make sure the water supply is open, that the drain pipe is not bent and that the siphon or filters are not clogged, set the selected program again.
Page 37
FAULTS CAUSE SOLUTION Reduce amount of detergent Use 5. Spray arms are Excessive amount of detergent suitable detergent not heard to Item prevents arms from rotating Check rotate Filtering plate and filter very dirty Clean filtering plate and filter 6. On electronic appliances without a Switch off the appliance.
Page 38
N.B.: Should any of the above situations result in a bad wash performance or insufficient rinsing, remove dirt deposits from the dishes by hand since the final drying cycle hardens the dirt, making it difficult to remove with a subsequent wash. If the malfunction continues, contact the Technical Assistance Centre, quoting the model of the dishwasher.
Page 39
20. ENVIRONMENTAL CONDITIONS l This appliance marked WEEE should treated cording to the European directive household waste; 2012/19/EUon Waste Electrical l WEEE should be handed over to the Electronic Equipment (WEEE). relevant collection points managed by WEEE contains both polluting substances municipality registered (which can cause negative consequences...
Page 40
Frequency range - Max Transmit Power - Minimum Receiving Sensitivity - Magnetic field limit Candy Hoover Group Srl With this the , declares that this appliance marked with complies with the essential requirements of the Directive 2014/53/EU. To receive a copy of the declaration of conformity, please contact the manufacturer at: www.candy-group.com...
Need help?
Do you have a question about the HDPN 4S622PW-AUS and is the answer not in the manual?
Questions and answers