Related Manuals for multicomp pro MP780969
Summary of Contents for multicomp pro MP780969
- Page 1 User Manual Combustible Gas Leak Detector Part Number: MP780969 Newark.com/multicomp-pro Farnell.com/multicomp-pro sg.element14.com/b/multicomp-pro Page <1> 10/01/25 V1.0...
- Page 2 Table of Content 1-Safety Symbols............3 2-General Safety Rules .
- Page 3 1-Safety Symbols In this operator’s manual and on the product, safety symbols and signal words are used to communicate information safety information. This section is provided to improve understanding of these signal words and symbols. This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.
- Page 4 • Maintain equipment. Check for misalignment or binding af moving parts, missing parts, breakage of parts and any other condition that may affect the equipment operation. If damaged, have the equipment repaired before use. Many accidents are caused by poorly maintained equipment. •...
- Page 5 Vibration Alert Vibration Alert Sensitivity <50ppm(methane) Response Time <2Seconds Range 0-10000ppm(methane) Sensitivity Level (methane) (HIGH) 5 Levels: 100/400/700/1000/>1000ppm Sensitivity Level (methane) (LOW) 5 Levels: 1000/4000/7000/10000/>10000ppm Warm Up Calibration Automatic Warm Up Time 50 Seconds Max Operating Buttons Seven: Power ON/OFF, High/Low Sensitivity, Audio Alerts, Vibration Alerts, Auto Zero, Auto Power Off, Hold Batteries Polymer Li-Ion Battery...
- Page 6 4-5. Controls & Display 1- Warm Up Indicator 2- Low Sensitivity lndk:ator(White) 3- Auto Zero Enable/Disable 4- Yibration Alert Enable/Disable 5- ON/OFF 6- Led Display 7- High Sensitivity lndicator{Yellow) 8- High/Low Sensitivity Selector 9- Auto Power Off Enable/Disable 10- Hold Enable/Disbale 11- Audible Alert Enable/Disable 4-6.
- Page 7 injury or incorrect measurements. • Clean any oil, grease or dirt from equipment. This aids inspection. • Inspect the micro MICRO Combusitble Gas Leak Detecor for any broken, worn, missing, misaligned or binding parts, or any other condition which may prevent safe and normal operation. •...
- Page 8 If locating a leak, use the gas detector to find areas of lower gas concentration and follow back to the source. In a piping system, trace the system, stopping at the joints to monitor the gas levels. • When gas detection is complete, turn the gas detecto OFF by pressing the ON/OFF button. Table 1-Gas Detector Feedback For Methane Concentration Levels Level Lights Low Sensitivity...
- Page 9 Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group’s liability for death or personal injury resulting from its negligence. Multicomp Pro is the registered trademark of Premier Farnell Limited 2019.
Need help?
Do you have a question about the MP780969 and is the answer not in the manual?
Questions and answers