Johnson Controls IP08-01T-GML-E Quick Start Manual page 3

Connecting the cameras
About this task:
To determine the compatibility of a particular camera model and firmware combination with exacqVision servers, use the following link:
www.exacq.com/support/ipcams.php.
1. Use the camera manufacturer's software to configure the IP addresses for each camera, and record this information for future reference.
For troubleshooting information on connecting cameras to the server, see https://support.exacq.com/#/knowledge-base/article/2075.
Note: Do not change the user name and password until after you establish connectivity with the exacqVision server.
2. To test the connectivity between the camera and the server, complete the following steps:
a. Log on to the operating system as an administrator.
b. In the address bar of your internet browser, type the camera's IP address.
c. Press Enter.
Note: If the browser does not display an introductory or logon window, the camera is not connected to the server. If the problem
persists, refer to the exacqVision User Manual, and https://support.exacq.com.
3. To add a camera, in the exacqVision client, select Configure System > Add IP Cameras > New and enter the camera address and
credentials.
To bulk add cameras, you can use the Find IP Cameras and Quick Add tabs. For detailed information, see the exacqVision User Manual.
4. Repeat this process for all other camera connections.
Accessing the server from a client workstation
You can configure the server through a remote exacqVision client.
1. Download the latest exacqVision client software from the Exacq website at: https://www.exacq.com/support/downloads.php.
2. Install the client software on a system administrator computer.
3. Use the ping command and the server's IP address to confirm connectivity. If the client PC cannot communicate with the server, contact
your network administrator.
Note: If the server does not connect to the client, check the remote client machine for antivirus software that can block
communication between the server IP addresses and ports.
Cybersecurity
Cybersecurity guidance for use in planning, deployment, and maintenance periods is available in the
For additional cybersecurity information and other resources, see
resources#AdditionalResources.
Hardware components
Figure 2: G-Series Micro front panel
G-Series Micro NVR Quick Start Guide
https://www.johnsoncontrols.com/trust-center/cybersecurity/
exacqVision Hardening Guide.
http://
3