Download Print this page

Regency F5200 Manual

Wood large stove (crib wood)

Advertisement

Quick Links

Model
Crib Wood BTU's
Emissions (grams/hr) EPA Certified
Efficiency (EPA HHV)*
Efficiency (EPA LHV)
Flue Size**
US Biomass Tax Rebate Eligible
Maximum Log Size
Firebox Size
* Cannot be reduced in size
**US Biomass Tax Rebate eligibility is based on the HHV value being
greater than or equal to 75%.
UNIT DIMENSIONS
ALL PICTURES / DIAGRAMS SHOWN THROUGHOUT THIS MANUAL ARE FOR ILLUSTRATION PURPOSES ONLY.
ACTUAL PRODUCT MAY VARY DUE TO PRODUCT ENHANCEMENTS.
F5200 Wood Large Stove (Crib Wood)
F5200
95,000 BTU's
0.84 grams/hr
80%
86%
8" (203 mm)
Yes
22" (559 mm)
4.4 cu.ft.
3
31
16 "
[792mm]
15
28
16 "
[735mm]
1
27
"
1
7
8 "
8
[689mm]
[181mm]
3"
[76mm]
Shown with optional fan
29"
[737mm]
WOOD STOVE OUTSIDE AIR DIMENSIONS
Rear
With pedestal from base of unit to centerline
5-1/2" (138mm)
8" (203mm) diameter flue
collar
F5200 Wood Stove |
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the F5200 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Regency F5200

  • Page 1 F5200 Wood Large Stove (Crib Wood) Model F5200 Crib Wood BTU’s 95,000 BTU’s Emissions (grams/hr) EPA Certified 0.84 grams/hr Efficiency (EPA HHV)* Efficiency (EPA LHV) Flue Size** 8" (203 mm) US Biomass Tax Rebate Eligible Maximum Log Size 22” (559 mm) Firebox Size 4.4 cu.ft.
  • Page 2 435mm 572mm" Minimum Alcove Clearance to Combustible Materials The Regency Freestanding models have been alcove approved and must be installed with a listed double wall connector to the ceiling level. Note: Minimum alcove ceiling height - 83" (2108 mm) H = Maximum depth of alcove - 48" (1219 mm) G= Minimum width of alcove - 63"...
  • Page 3 (1143mm) (1918mm) (1643mm) (860mm) 45" 73-1/2" 63-11/16" 31-7/8" (1143mm) (1867mm) (1618mm) (810mm) Reference only when hearth pad is installed to rear wall at minimum pipe clearances. Residential Close Clearance (To be installed with required pipe components) F5200 Wood Stove |...
  • Page 4 11. WARNING: DO NOT INSTALL IN A SLEEPING ROOM OF A MOBILE HOME. 12. Use silicone to create an effective vapour barrier at the location where the chimney or other component penetrates to the exterior of the structure. | F5200 Wood Stove...
  • Page 5 This chimney cannot be reduced in cross NOTE: Approved with listed double wall pipe only. sectional area. Do not use single wall pipe. 6" [152mm] Min. 36" Max. 36" Vertical Horizontal Rise 10" [254mm] F5200 Wood Stove |...
  • Page 6 Cover opening with and support chimney section on both sides with 24 gage minimum sheet metal supports. See that the supports are fastened securely to wall surfaces on all sides. Make sure fasteners used to secure chimney flue liner. | F5200 Wood Stove...
  • Page 7 5. Place the storm collar over the flashing, sealing the joints with a silicone caulking. 6. Fasten the raincap with spark screens (if required) to the top of your chimney. Horizontal Installation F5200 Wood Stove |...
  • Page 8 16.0 18.5 20.0 7000-8000 15.5 16.5 19.0 20.5 8000-9000 16.0 17.0 20.0 21.0 9000-10000 16.5 17.5 20.5 22.0 NOTE: No more than one offsets (two elbows) allowed. Two 45 elbows equal one 90 elbow. Table 1 | F5200 Wood Stove...