Vpn Wizard Gateway Setting; Figure 30 Vpn Wizard: Gateway Setting; Table 17 Vpn Wizard: Gateway Setting - ZyXEL Communications ZYWALL 35 User Manual

3.3 VPN Wizard Gateway Setting

Use this screen to name the VPN gateway policy (IKE SA) and identify the IPSec routers at
either end of the VPN tunnel.
Click VPN Setup in the Wizard Setup Welcome screen
VPN configuration wizard. The first screen displays as shown next.

Figure 30 VPN Wizard: Gateway Setting

The following table describes the labels in this screen.

Table 17 VPN Wizard: Gateway Setting

LABEL
Gateway Policy
Property
Name
My ZyWALL
ZyWALL 5/35/70 Series User's Guide
DESCRIPTION
Type up to 32 characters to identify this VPN gateway policy. You may use any
character, including spaces, but the ZyWALL drops trailing spaces.
When the ZyWALL is in router mode, enter the WAN IP address or the domain name
of your ZyWALL or leave the field set to 0.0.0.0.
The following applies if the My ZyWALL field is configured as 0.0.0.0:
When the WAN interface operation mode is set to Active/Passive, the ZyWALL uses
the IP address (static or dynamic) of the WAN interface that is in use.
When the WAN interface operation mode is set to Active/Active, the ZyWALL uses
the IP address (static or dynamic) of the primary (highest priority) WAN interface to
set up the VPN tunnel as long as the corresponding WAN1 or WAN2 connection is
up. If the corresponding WAN1 or WAN2 connection goes down, the ZyWALL uses
the IP address of the other WAN port.
If both WAN connections go down, the ZyWALL uses the dial backup IP address for
the VPN tunnel when using dial backup or the LAN IP address when using traffic
redirect. See the chapter on WAN for details on dial backup and traffic redirect.
When the ZyWALL is in bridge mode, this field is read-only and displays the
ZyWALL's IP address.
Chapter 3 Wizard Setup
(Figure 18 on page 85) to open the
95