Related Manuals for LMI Technologies GoMax ORIN
Summary of Contents for LMI Technologies GoMax ORIN
- Page 1 GoMax ORIN / ORIN+ Smart Vision Accelerator Quick Start Guide 15xxx-01.01_MANUAL_Quickstart_GoMax_ORIN_ORIN+...
- Page 2 Getting Started with the GoMax ORIN / ORIN+ Congratulations on purchasing a GoMax ORIN or ORIN+ Smart Vision Accelerator. This Quick Start Guide provides you with the resources to get you started. Customer Support If you have any installation issues, please contact:...
- Page 3 Hardware Included with GoMax ORIN / ORIN+ When you receive your GoMax ORIN or ORIN+ shipment, check that all components are included: Number Description GoMax ORIN or ORIN+ unit (not shown) Power supply, cord (plug depends on part number of the kit), and Phoenix...
- Page 4 Connecting Power To connect the power, do the following. WARNING: Use only the provided power supply with the GoMax unit. Using a higher voltage power supply will damage the unit. 1. Connect the power supply connector to the unit. 2. Plug the power adapter into an available electrical outlet. The power button LED indicator lights.
- Page 5 Setting the IP Address Each GoMax unit and Gocator sensor on the sensor system network must have a unique IP address. To set the IP address of a GoMax unit, do the following: 1. Using an Ethernet cable, connect a computer to the ETH1 port on the GoMax unit. IP: 192.168.1.x Mask: 255.255.255.0...
- Page 6 3. In the Manage panel, click the Networking category. The Networking category settings are displayed. 4. Under Interface 1, set the IP address and click Save. The GoMax unit power cycles after you confirm you want to change any IP addresses. Changing network settings disconnects the GoMax unit and stops the acceleration of any accelerated sensors.
- Page 7 LMI provides a DIN rail clip plate, two DIN rail clips, and M3 screws to mount GoMax ORIN / ORIN+ on a DIN rail. The plate allows two orientations of the unit using different sets of standoffs. Attach the DIN rail clip plate to the back of the unit, and attach the DIN rail clip to the plate in the required orientation.
- Page 8 Connecting to a Sensor System Typically, you connect the GoMax unit to a sensor system through a Gigabit switch the sensor is connected to. Connect the unit to the switch using an Ethernet cable and the ETH1 port on the unit.
- Page 9 Using GoMax ORIN / ORIN+ To accelerate a sensor, do the following: 1. Connect a computer to the switch using an Ethernet cable. 2. On the computer, using a web browser, connect to the GoMax web interface using the unit’s IP address.
- Page 10 3. Under Sensors, in the Visible Sensors list, click the toggle to the right of the sensor you want to accelerate. The sensor is now accelerated. To access an accelerated sensor, do the following: • Under Sensors, in the Accelerated list, click the sensor’s serial number to the left. A page providing a link to the accelerated sensor’s web interface opens in a new tab.
- Page 12 LMI Technologies, their partners, and resellers accept no liability for any damages (personal or to property) incurred as a result of improper use, incorrect assembly, failure to adhere to safety precautions, and/or mistreatment of this product (including its components). Copyright © 2024 LMI Technologies Inc. All rights reserved.
Need help?
Do you have a question about the GoMax ORIN and is the answer not in the manual?
Questions and answers