Advertisement
Quick Links
Advertisement
Related Manuals for LMI Technologies GoMax NX
Summary of Contents for LMI Technologies GoMax NX
- Page 1 GoMax NX Smart Vision Accelerator Quick Start Guide 15266-01.02_MANUAL_Quickstart_GoMax_NX...
- Page 2 +1 604 636 1011 EMEAR LMI Technologies GmbH Berlin, Germany +49 (0)3328 9360 0 ASIA PACIFIC LMI (Shanghai) Trading Co., Ltd. Shanghai, China +86 21 5441 0711 LMI Technologies has sales offices and distributors worldwide. All contact information is listed at lmi3D.com/contact.
- Page 3 Power supply, cord (plug depends on part number of the kit), and Phoenix connectors DIN rail clip plate DIN rail clip Wall mount brackets (x2) Screws (x7, not shown) Before connecting the GoMax NX unit to a sensor system, follow the instructions in “Connecting Power” and “Setting the IP Address”.
-
Page 4: Connecting Power
Connecting Power To connect the power, do the following. WARNING: Use only the provided power supply with the GoMax NX unit. Using a higher voltage power supply will damage the unit. 1. Connect the power supply connector to the unit. - Page 5 3. Press the power button. The power button LED indicator lights.
-
Page 6: Setting The Ip Address
Setting the IP Address Each GoMax NX unit and Gocator sensor on the sensor system network must have a unique IP address. By default, the IP addresses of the GoMax NX rightmost Ethernet port is set to 192.168.1.6. To set the IP address of a GoMax NX unit, do the following: 1. - Page 7 4. Under Interface 1, set the IP address and click Save. The GoMax NX unit power cycles after you confirm you want to change any IP addresses. Changing network settings disconnects the GoMax unit and stops the acceleration of any accelerated sensors.
- Page 8 LMI provides a DIN rail clip plate, a DIN rail clip, and M3 screws to mount GoMax NX on a DIN rail. The plate allows multiple orientations of the unit using different sets of standoffs. Attach the DIN rail clip plate to the back of the unit, and attach the DIN rail clip to the plate in the required orientation.
- Page 9 LMI also provides wall mount brackets to mount the GoMax NX unit directly on a wall or to a frame. To use the wall mount brackets, remove the DIN rail clip plate from the back of the unit, and attach the wall mount brackets to the back of the unit using the provided screws. Make sure that the unit is securely fastened to the wall.
- Page 10 Connecting to a Sensor System You must connect the GoMax NX unit to a sensor system through the Gigabit switch the sensor is connected to. Connect the unit to the switch using an Ethernet cable and the ETH1 port on the unit.
- Page 11 Using GoMax NX To accelerate a sensor, do the following: 1. Connect a computer to the switch using an Ethernet cable.
- Page 12 2. On the computer, using a web browser, connect to the GoMax NX web interface using the unit’s IP address. The GoMax NX web interface is displayed. The Sensor System category is preselected in the Manage panel. In the following, a multi-sensor system is used.
- Page 13 A page providing a link to the accelerated sensor’s web interface opens in a new tab. Configure the sensor as you normally would. For information on configuring a sensor, see the sensor’s user manual. For more information on using GoMax NX, see the GoMax NX user manual.
- Page 14 LMI Technologies, their partners, and resellers accept no liability for any damages (personal or to property) incurred as a result of improper use, incorrect assembly, failure to adhere to safety precautions, and/or mistreatment of this product (including its components). Copyright © 2022 LMI Technologies Inc. All rights reserved.