Preparations - Aiwa NSX-D20 Operating Instructions Manual

PREPARATIONS

Connection
Plug in the AC power cord to the AC power outlet after all other
connections are made.
1 Connect the front speakers.
Connect the right front speaker to the SPEAKERS R
terminals and place it on the right side of the unit. Connect
En
the left to the SPEAKERS L terminals and place it on the
left side.The speaker cords with the white stripes go to
the 0 terminals.
2 Connect the surround speakers (only for NSX-
D22)
Connect each surround speaker cord to the SURROUND
SPEAKERS R jack or the SURROUND SPEAKERS L jack.
4
3 Connect the supplied antennas.
Strip off the insulation of the FM antenna with twisting
the cord.
Connect the FM antenna to the FM 75 Ω terminal without
the 2 mark and the AM antenna to the AM LOOP
terminals.
AM antenna
FM antenna
4 Connect the AC power cord to an AC outlet.
When the AC power cord is connected to an AC outlet for
the first time, DEMO appears on the display.
To deactivate the DEMO, press DEMO/ECO.
•Do not short-circuit the 0 and 9 speaker cord leads.
•Do not leave objects generating magnetism or objects
affected by magnetism near the speakers.
To position the surround speakers (only for NSX-D22)
Position the surround speakers behind the listening area to
make the most of the surround effect.
AIWA disclaims any responsibility for injury to persons
or other accidents caused by not fitting the surround
speakers properly or if the place of the installation is not
suitable.