Reset/Encrypt Button Behavior - ZyXEL Communications PLA4201 User Manual

Congratulations. You now have two separate powerline networks as shown above.
If the HomePlug (
devices are not connected. Repeat the connection process, making certain you press the
RESET/ENCRYPT buttons for the correct time and within two minutes of each other. If that
does not work see Section 6.5 on page 45 for suggestions.

3.4 RESET/ENCRYPT Button Behavior

The following table summarizes the actions that occur when the RESET/ENCRYPT button is
pressed for specific lengths of time.
Table 2 Time RESET/ENCRYPT Button is Pressed and Action
TIME
0.5 to 3
seconds
5 to 8
seconds
10 to 15
seconds
See Troubleshooting in
ENCRYPT button and the lights.
PLA4201 User's Guide
) lights on both powerline devices do not light up, the powerline
ACTION
The device joins a network. It
shares the same network
name as other devices on the
network.
The device leaves any
network it is associated with
and its network name
assumes a random value.
Clear all user-entered
configuration information and
return the device to its
factory defaults.
Chapter 6 on page 45
Chapter 3 The RESET/ENCRYPT Button
POWER LIGHT BEHAVIOR
The power ( ) light blinks
until the device is connected.
This may take a minute.
The power ( ) light blinks
several times and then shines
steadily.
The power ( ) light blinks
several times and then shines
steadily.
for suggestions on problems with the RESET/
HOMEPLUG LIGHT
BEHAVIOR
The HomePlug ( ) light turns
on if your device is connected
to another powerline device or
a powerline network.
The HomePlug ( ) light blinks
red one time and then turns off
when it disconnects from the
powerline network.
The HomePlug ( ) light blinks
red one time and then turns off
when it disconnects from the
powerline network.
21