C-LITE C-FL-B-FLW-9L Series Installation Instructions Manual page 2

INSTALLATION INSTRUCTIONS
C-FL-B-FLW (9L and 14L) Series
MOUNTING USING 1/2" FITTER
NOTE: Fixture can be mounted to any metal 1/2" NPSM threaded
mounting (supplied by others).
NOTE: When mounting the fixture in an inverted position (1/2" fitter
above fixture), mount fixture to a watertight junction box and cover.
Also, caulk the conduit openings, around the junction box cover, and
the wire entry end of the 1/2" fitter with a high grade caulking material,
such as silicone rubber, to ensure water does not enter fixture through
1/2" fitter.
1. 1. Route fixture's 18AWG power cord through upper and lower
sections of 1/2" fitter. Cord should exit threaded base of fitter. See
Figure 2.
2. Attach 1/2" fitter to (2) threaded holes on fixture housing using
supplied Allen bolts and Allen wrench. Make sure gasket is
properly positioned between upper fitter and housing. Tighten the
bolts.
3. Route fixture's power cord through hole in mount.
4. Thread mounting onto end of fitter on fixture and secure with
locknut. Using thread sealant on the threads will ensure a
watertight seal.
5. See Color Temperature, and Photocell Settings section to set
wattage, CCT, and to enable or disable photocell (if present).
6. Wire as indicated in Electrical Connections section.
7. Aim fixture by loosening screw on knuckle of fitter and rotating
fixture to desired tilt angle. Re-tighten screw.
FIGURE 2
Threaded Holes
Lower Fitter
Gasket
Upper Fitter
(2) Allen Bolts
1/2" Locknut
http://lighting.cree.com/warranty
Document: LPN00872X0003A0_A
Created By: TMT
COLOR TEMPERATURE, and PHOTOCELL
SETTINGS
in photocell may occur.
1. Remove the selector switch cap on the side of the fixture housing
using a large straight blade screwdriver. See Figure 3.
2. Locate the selector switches under the cap and select color
temperature by sliding the dip switches to the desired values. See
Figure 4 and 5.
3. Position photocell switch to "ON" position to enable photocell
switching of fixtures. Position photocell switch to "OFF" position to
disable photocell. See Figure 4 and 5.
4. Replace the selector switch cap and retighten using a large
straight blade screwdriver.
FIGURE 3
Selector Switch Cap
FIGURE 4 - Switch used for C-FL-B-FLW-9L-SCCT
Photocell Activation
FIGURE 5 - Switch used for C-FL-B-FLW-14L-SCCT
Color Temperature
| 1-800-236-6800
Date 2-5-2024
Color Temperature
Photocell Activation