Add/Edit A Qos Queue; The Class Setup Screen - ZyXEL Communications P-661HNU Manual

10.3.1 Add/Edit a QoS Queue

Use this screen to configure a queue. Click Add new queue in the Queue Setup
screen or the Edit icon next to an existing queue.
Figure 72 Queue Setup: Add/Edit
The following table describes the labels in this screen.
Table 39 Queue Setup: Add/Edit
LABEL
Active
Name
Interface
Priority
Weight
Rate Limit
Apply
Back

10.4 The Class Setup Screen

Use this screen to add, edit or delete QoS classifiers. A classifier groups traffic into
data flows according to specific criteria such as the source address, destination
address, source port number, destination port number or incoming interface. For
P-661HNU-Fx User's Guide
DESCRIPTION
Select to enable or disable this queue.
Enter the descriptive name of this queue.
This shows the name of the ZyXEL Device's interface through which traffic
in this queue passes.
Select the priority level (from 1 to 7) of this queue.
The larger the number, the higher the priority level. Traffic assigned to
higher priority queues gets through faster while traffic in lower priority
queues is dropped if the network is congested.
Select the weight (from 1 to 15) of this queue.
If two queues have the same priority level, the ZyXEL Device divides the
bandwidth across the queues according to their weights. Queues with
larger weights get more bandwidth than queues with smaller weights.
Specify the maximum transmission rate (in Kbps) allowed for traffic on
this queue.
Click Apply to save your changes.
Click Back to return to the previous screen without saving.
Chapter 10 Quality of Service (QoS)
181