Netbios Filter Configuration; Table 79 Netbios Filter Default Settings - ZyXEL Communications P-660R-D Series User Manual

P-660R-D Series User's Guide
The filter types and their default settings are as follows.

Table 79 NetBIOS Filter Default Settings

NAME DESCRIPTION
Between LAN This field displays whether NetBIOS packets are blocked or forwarded
and WAN between the LAN and the WAN.
IPSec Packets This field displays whether NetBIOS packets sent through a VPN
connection are blocked or forwarded.
Trigger dial This field displays whether NetBIOS packets are allowed to initiate
calls. Disabled means that NetBIOS packets are blocked from initiating
calls.

NetBIOS Filter Configuration

Syntax:sys filter netbios config <type> <on|off>
where
<type> =
<on|off> =
Example commands
sys filter netbios
config 0 on
sys filter netbios
config 3 on
sys filter netbios
config 4 off
2
Identify which NetBIOS filter (numbered 0-3) to configure.
0 = Between LAN and WAN
3 = IPSec packet pass through
4 = Trigger Dial
For type 0 and 1, use on to enable the filter and block NetBIOS
packets. Use off to disable the filter and forward NetBIOS packets.
For type 3, use on to block NetBIOS packets from being sent
through a VPN connection. Use off to allow NetBIOS packets to be
sent through a VPN connection.
For type 4, use on to allow NetBIOS packets to initiate dial backup
calls. Use off to block NetBIOS packets from initiating dial backup
calls.
This command blocks LAN to WAN and WAN to LAN NetBIOS
packets.
This command blocks IPSec NetBIOS packets.
This command stops NetBIOS commands from initiating calls.
EXAMPLE
Block
Forward
Disabled
Appendix G NetBIOS Filter Commands