Figure 144 Network > Tcp/Ip; Table 43 Network > Tcp/Ip - ZyXEL Communications NSA-2401 User Manual

Figure 144 Network > TCP/IP
The following table describes the labels in this screen.
Table 43 Network > TCP/IP
LABEL
Teaming Mode
LAN
Dynamic
NSA-2401 User's Guide
DESCRIPTION
Select how to use the NSA's two Gigabit Ethernet interfaces.
Stand Alone: Select this option to use a separate IP address on each of the two
Gigabit Ethernet interfaces.
Fault Tolerance: Select this option to use the LAN2 Gigabit Ethernet interface as
a fail-over (backup) for the LAN1 Gigabit Ethernet interface. Both Gigabit
Ethernet interfaces are connected to the same subnet. There is one IP address. If
LAN1 loses its connection, LAN2 takes over the IP address and traffic.
Load Balancing: Select this option to use both Gigabit Ethernet interfaces on the
same subnet with the same IP address. The NSA distributes the traffic load
across both interfaces.
Link Aggregation: Select this option to use IEEE 802.3ad port link aggregation
to combine the two Gigabit Ethernet interfaces into a single logical link. Connect
both Gigabit Ethernet interfaces to the same device. The peer device must also
have IEEE 802.3ad port link aggregation enabled for the two interfaces
connected to the NSA. Both interfaces use the same IP address. If one interface
loses its connection, the NSA continues to use the other interface.
Use this section to configure the NSA's IP address or IP addresses (configure
LAN1 and LAN2 separately when the Teaming Mode is set to Stand Alone).
Select the Dynamic checkbox to have a DHCP server automatically assign an IP
address to your NSA. If none is assigned, then the NSA reverts to the default IP
address of 192.168.1.3.
Chapter 7 Network Screens
163