Amba Traditional T-2536 Installation Instructions

TRADITIONAL T-2536
INSTALLATION INSTRUCTIONS
WARNINGS
PLEASE READ THE FOLLOWING INFORMATION BEFORE INSTALLING AND USING YOUR HEATED TOWEL RACK.
1. These units should be installed by a certified electrician in accordance with the National Electrical Code (NEC) and the Canadian Electrical
Code ( CEC).
2. The unit requires a 115 volt, 60Hz power source and should be installed on a GFCI protected circuit.
3. Follow installation instructions to ensure unit is securely fixed to wall. Unit is designed for drying towels. Under no circumstances should
anybody climb on or hang on unit.
4. The unit must be installed in an upright position with the wire cover tube/junction box being positioned at the bottom.
5. Unit is intended for indoor use only. Do not place units inside a shower, sauna, steam room, or wherever unit would be exposed to water.
6. To reduce the risk of electric shock, burns, fire or injury:
• Close supervision is necessary when this unit is used near children or disabled persons.
• Use this unit only for its intended use as described in this manual.
• Do not use outdoors.
• Do not operate with a voltage converter.
• Do not touch hot surfaces.
• Do not use accessories or attachments not recommended by the manufacturer as this may cause injuries.
CAUTION
1. As this is a heating device, the surface temperature can increase depending on the ambient temperature in the room and the number of
towels applied to the unit.
2. The fasteners provided with the installation kit are for convenience only and are not suitable for all installation conditions.
3. It is the ultimate responsibility of the installer to ensure proper mounting hardware is employed in attaching the unit to the wall.
OPERATING INSTRUCTION
1. After installation, connect the electric power.
2. Turn on the wall switch (sold separately) and towel warmer will start to heat-Allow 30-40 minutes to heat up.
3. This towel warmer has been designed to run continuously- turn off at wall switch when the towel warmer is not in use for long periods
of time.
CARE AND MAINTENANCE
1. Towels which contain soap or detergent residue may appear to have scorch marks; this is simply discoloration of the residue in the
towels themselves.
2. The unit is constructed from extremely durable low carbon steel. To maintain a good appearance, follow these simple instructions:
• For routine cleaning, simply switch off the unit, allow to cool to room temperature, wipe with a damp cloth and buff with a soft,
dry cloth.
• Under no circumstances should abrasive cleaners be used to clean the unit.
• If the product is damaged, do not repair by yourself, please return to the maintenance center for possible repair.
INCLUDED COMPONENTS
ELECTRICAL INFO
WATTS
150
! CAUTION — SURFACE OF UNIT IS HOT WHEN ON !
RECOMMENDED
AMPS VOLTS
1.3 115
Ø8mm
HEATED TOWEL RACKS
TOOLS
WARRANTY
Two year limited
warranty with proof of
purchase will apply if all
Terms and Conditions
of Sale are met and
Installation Instructions
are adhered to.
5008694
Page 1