Troubleshooting - LENCO MDV-3 Instruction Manual

TROUBLESHOOTING

NOTE: In most cases, whether the DVD player can work properly depends on the disc it plays,
some functions listed in the instruction manual may not work properly due to disc problems,
therefore, it is strongly recommended to read through this instruction manual first before using this
DVD player. For your convenience, we have listed some methods to solve this problems you may
encounter when using the DVD player. If the failure occurs repeatedly, please contact the nearest
maintenance center to your house.
Failure
Cannot operate the
player with the
remote control
Cannot play discs
No disc menu is displayed
Play mode is different
from what has been
chosen in the SETUP MENU
Picture distortion or no
colour displayer
No picture is produced
or picture is produced
asynchronously
The picture distorts or
is out of control
No sound is produced
Other failures
Forgot the parental
control password
Check the batteries in the remote controller to see if it is
needed to replace the batteries.
Use the remote controller within 6 meters from the DVD
player, and direct the remote controller to the front panel of
the DVD player.
Be sure that the disc is placed on the tray with the label
facing up.
Play discs compatible with the DVD player.
The player is under protective status against strong outer
intervention.
Please switch off the player for a wile and switch on again.
Grade limitation is preset. please relieve the limitation first.
Check if there is menu recorded in this disc
If the disc has no corresponding function codes, some
function selected in the SETUP MENU may not work
properly
The TV system or video output of this player is not the
same sd the TV set, please reset the TV system.
The setup of the video output does not match the way of
connection of this unit with the TV set, please do the setup
correctly.
When playing discs that are seriously scratched or has
interior defects, of when the unit is affected by strong outer
electromagnetic field, this problem will occur and the
normal operation of this unit will be affected.
Please turn off the power for a while and turn in on again.
Use quality the quality disc and it can resume work
normally.
Usually detected disc may shorten the service life of this
unit.
Cancel mute mode or turn up the volume.
Refer to the instruction manual for methods to solve the
problem, do as directed in the Instruction Manual.
If the problem continues to exist, please contact the
nearest maintenance center to you.
grade
Use the super password.
- 23 -
Remedy