LENCO CS-190 DVD Owner's Manual page 16

Mobile video system fold down and removable panel 3.0 inch tft monitor dvd player multi-subtitle/audio languages function remote contro
Table of Contents

Advertisement

current frequency and checks the signal
strength until one cycle search is finished. And
then 6 strongest stations are stored into the
corresponding preset number button.
AS(Auto Store): Press AS/PS button shortly
to scan preset station. When the field strength
level is more than the threshold level of stop
level, the radio is holding at that preset number
for several seconds with release mute, then
searches again.
5. RDS MENU SETTING
Press and hold the VOL/SEL buttonfor 2
seconds to activate as the following functions
for user's selection.
TA SEEK or ALARM→PI SOUND or
MUTE→RETUNE L or S→ MASK DPI or
ALL→BEEP ON→OFF
By rotating the volume knobclockwise or
counter-clockwise, it is possible to adjust the
desired setting.
a) TA SEEK OR TA ALARM
-
TA SEEK mode:
When newly tuned station does not
receive TP information for several
seconds, the radio retunes to next
station which has not the same station
(PI) as the last station, but has the TP
information.
When TP information gets lost at the
current station for retune time which is
set by RETUNE SHORT (30 sec.) or
RETUNE LONG (90 sec.), the radio
start to retune to next same PI station.
When same PI station does not catch
in 1 cyclic search, the radio retunes to
next station with TP
information.
-
TA ALARM mode:
When this mode is selected, any
automatic retune mode is not activated.
Only double beep sound (ALARM) is
output.
When newly tuned station does not
have
TP
seconds, beeps come out.
When TP information gets lost at the
current station for retune time, the
beep sound is out-putted.
When newly tuned station has not
RDS signal, "PI SEEK" is suppressed
somewhat.
b)
PI SOUND or PI MUTE
While AF switching is implemented in
C201 station, AF can switch to 100 MHz,
which is non genuine AF (where,
different PI with same AF) in short "DIP".
If a car cruises that critical area back and
forth, an oscillation phenomenon can be
occurred, because the different PI code
can be received from 100 MHz with
"XXX" PI. The car radio has special
procedure to reduce even this kind of
unavoidable situation however there is a
limit to be escaped from this serious
case perfectly. In that serious case, 2
mode is selectable as follows:
98
90
100
PI: C201
17
information
for
several
100
PI: XXX

Advertisement

Table of Contents
loading

Table of Contents