Page 1
Shredder User Manual 1-800-327-8508 USA Only • Los Estados Unidos Solomente 1-310-793-5650 International • Internacional Email: info@auroracorp.com For more information, please visit us at: AU660S www.auroracorp.com Please read these operating instructions before using the unit. Model No.
Page 3
WARNING : SAFETY INSTRUCTIONS, READ BEFORE USING! Do not spray or keep any aerosol products in or around the Read instructions before use. shredder. Avoid touching the document Keep loose clothing or jewelry feed opening with hands. away from the paper entry slot. Product is not intended for use by Avoid getting hair near the children (product is not a toy).
Page 4
Paper Shredder Sheet Capacity 6 Sheets of 20 lb. bond paper* Operating Instructions Installation Paper Shred Size: 1/4” (0.6 cm) wide strips Operation Paper Feed Entry Width 8.7" (22 cm) Maintenance Troubleshooting Credit Card Capacity Only one per pass Service Center Duty Cycle 2 min.
Page 5
OPERATION Control Switch Using the switch located on the unit, select one of the following settings FIGURE 2 by sliding the switch either left or right. (FIGURE 2) AUTO: This setting allows the shredder to be automatically started by inserting paper into the feed slot. Al- ways feed the paper in as straight as possible.
Page 6
OPERATION LED Status Indicators: • Ready (Power On): Ready (Power On) / The Green LED light indicates the shredder is “On” Overheat and ready to operate when paper is inserted. • Overheat: Red light – Shredder has shred continuously beyond the maximum shred time and needs to cool down before operation can restart.
Page 7
MAINTENANCE Warning: Failure to properly maintain your shredder will void the warranty. Oil the shredder blades every month with basic vegetable, cooking oil or shredder oil. Follow oiling procedure below (FIGURE 3). It helps to keep the shredder blades operating well over many years of use. Oiling procedure: 1. Turn off shredder. 2.
Page 8
TROUBLESHOOTING If there is a problem with your shredder, check below for the symptoms and steps to resolve. If you continue to have problems, contact customer support at our Service Center 1-800-327-8508. DO NOT ATTEMPT TO REPAIR BY OPENING THE SHREDDER HEAD. This will completely void the product warranty.
Page 9
TROUBLESHOOTING Power switch in auto position Use thick paper stock or greeting card to push the jam through 3) As a safety precaution, ensure that the shredder is switched off and unplugged from the electrical to avoid injury. You may use Tweezers, flat-head screwdriver, or long-nose pliers to remove any pieces of paper stuck on the bottom of the blades. Note: When using tools, it's crucial not to damage the shredder's blades. The shredder is constantly running while in “Auto (On)” mode.
Page 10
Should there be a defect or malfunction of this product, Aurora will repair or replace the product free of charge. Customer is responsible for all shipping charges to return the defective product to Aurora. A copy of the proof of purchase showing original purchase date is required.
Need help?
Do you have a question about the AU660S and is the answer not in the manual?
Questions and answers