Eizo FP-301 User Manual

NOTE
• Please be careful not to scratch the LCD panel or the cabinet with the panel protector during installation. Also
please do not remove the panel protector often. It may scratch or result in damage to the LCD panel.
• When using LCD monitor with optional panel protector, it is preferable to avoid using downwards. In this
condition, the panel protector might become bend or slip out from the monitor.
Installation
Before installation, please remove dust and stains from the LCD panel.
1.
Set the panel protector into the grooves of the panel frame; the lower first (1), then the upper
1.
(2).
With the enclosed tool (Lever) set the tabs of the panel protector into the side grooves (2 tabs).
2.
Put the lever on the tabs of the panel protector and move it toward the LCD panel to install. Position the protector
into the LCD panel tightly without leaving an opening.
Removing
Put the lever on the tabs of panel protector and move it toward the cabinet to remove.
Cleaning
NOTE
• Please be sure to keep the panel protector immobilized while cleaning it. Otherwise it may scratch the surface of
the LCD panel. To hold the panel protector by hand, use a soft cloth to avoid dust or finger prints.
• Never use thinner, benzene, alcohol (ethanol, methanol, or isopropyl alcohol), abrasive cleaners, or other strong
solvents, as these may cause damage to the cabinet or panel.
•
It is recommended to use EIZO cleaning kit "ScreenCleaner" (option) to clean the panel.
The panel surface can be cleaned with a soft cloth such as cotton or lens paper.
If necessary stubborn stains can be removed by moistening part of the cloth with water to enhance its
cleaning power.
Specification
Surface treatment Non glare hard coating
Coating strength 2H
Reflectivity Less than 6.5 %
Light transmission More than 87 %
Dimension/ Weight FP-301: 307.3 mm (W) × 231.7 mm (H) × 0.8 mm (D) / approx. 70 g
FP-401: 320.2 mm (W) × 257.0 mm (H) × 0.8 mm (D) / approx. 85 g
FP-501: 341.0 mm (W) × 274.2 mm (H) × 0.8 mm (D) / approx. 90 g
FP-601: 363.0 mm (W) × 291.6 mm (H) × 0.8 mm (D) / approx. 90 g
FP-701: 379.8 mm (W) × 304.5 mm (H) × 1.0 mm (D) / approx. 140 g
FP-801: 412.5 mm (W) × 310.5 mm (H) × 1.0 mm (D) / approx. 154 g
FP-901: 435.6 mm (W) × 327.9 mm (H) × 1.2 mm (D) / approx. 210 g
Accessories Lever (for Panel Protector), User's Manual
Copyright© 2006 EIZO NANAO CORPORATION All rights reserved.
2.
00N0L248A1