Chapter 5 Reference; Attaching An Arm - Eizo FLEXSCAN S2401W User Manual

Chapter 5 Reference

5-1 Attaching an Arm

The stand can be removed and replaced with an arm (or another stand) to be
attached to the monitor. Use an arm or stand of EIZO option.
[Attaching]
1
Lay the LCD monitor on a soft cloth spread over on a stable
surface with the panel surface facing down.
2
Remove the stand. (Prepare a screwdriver.)
Unscrew the four screws securing the unit and the stand with the
screwdriver.
3
Attach the monitor to the arm or stand.
Secure the monitor to the arm or stand using the screws specified in the
user's manual of the arm or stand.
30
Chapter 5 Reference
Attention
• When attaching an arm or stand,
follow the instructions of their user's
manual.
• When using another manufacturer'
s arm or stand, confirm the following
in advance and select one conforming
to the VESA standard. Use the M4
× 12 mm screws supplied with this
monitor.
– Clearance between the screw holes:
100 mm × 100 mm
– Thickness of plate: 2.6 mm
– Strong enough to support weight of
the monitor unit (except the stand)
and attachments such as cables.
• When using an arm or stand, attach it
to meet the following tilt angles of the
monitor.
– Height adjustable stand:
Up 40 degrees, down 0 degrees
(vertical display, 90 degrees
clockwise)
– EZ-UP stand:
Up 25 degrees, down 0 degrees
(vertical display, 90 degrees
clockwise)
• Connect the cables after attaching an
arm.
• If you need to remove the EZ-UP
stand, turn the panel on the monitor
to the left and right a little to appear
the four screws positioned under the
stand. Then unscrew the four screws.