Related Manuals for Autoplugin Therminal-V3
Summary of Contents for Autoplugin Therminal-V3
- Page 1 Autoplugin Therminal-V3 Version 10.7 Technical Description Installation Manual Rev. A...
-
Page 2: Table Of Contents
9. Troubleshooting………………………………………………………… 10. Glossary……………………………………………………………… Description The Autoplugin Therminal-V3 is a kit intended for remote control of the fuel- fired heater (parking heater, fuel operated heater, pre-heater), factory installed on Volvo С30 (2006-2012), S40 (2004-2012), V50 (2004-2012) or C70 (2006-2013). The kit includes two modules: the climatic GSM-module Therminal-XC/XE/XF and the interface module RCP Light-V3. -
Page 3: Basic Functions
4. Permanent connection cable 5. Plug-n-play cable 6. Thermo sensor with cable 7. LED-button with cable 8. Technical Description and Installation Manual brochure 9. User Manual brochure Basic Functions 1. Refer to the User Manual to know how control the heater from a mobile phone or a smartphone. -
Page 4: Plug-N-Play Connection
GSM-module is supplied without SIM card inside. The customer should buy a SIM card with subscription to local GSM provider services (SMS and GPRS are required). Possibly you should make some preparatory operations with SIM before installation to the GSM-module: 1. -
Page 6: Permanent Connection
Play cable by straps and fix all the cables of kit inside the dashboard. Finally connect Plug-n-Play cable to the OBD-II service socket. Permanent connection It is recommended to install Autoplugin Therminal permanently under the dashboard. Make all the steps listed in chapter above. Then take permanent connection cable and cconnect free ends of the cable to the car’s wiring in accordance with Table 1. -
Page 7: Rcp Light-V3 Additional Functions
Connect separated thermo sensor to the GSM module (instead of connector with single orange wire of interconnection cable) and fix it with adhesive pad at the place where temperature will be registered. Shorten wires of permanent connection cable by place, as required. Plug permanent connection cable to the interconnection cable. - Page 8 Settings Table (2) 2.1. “Lock” and 2.1.1 *”Lock” button for heater start, Heater “Lamp” buttons “Lamp” button for heater stop control with functions for heater 2.1.2 “Lamp” button for heater start, remote control “Lock” button for heater stop control key 2.2.
-
Page 9: Troubleshooting
Troubleshooting If you have problems with heater startup try sequentially start the heater from a key, then from the button and finally – from a phone. When the heater doesn’t start at all, make diagnostics beginning with the RCP Light. If the heater starts from a key, make diagnostics of the GSM-module. - Page 10 o GSM-module diagnostics If the heater doesn’t start from the button, check all the kit connections. Startup from the button operates independently from GSM network status. In case when the heater starts from the button, but doesn’t start via GSM (SMS, voice call or app) use GSM-module indication for diagnostics: press and hold the button until the embedded LED flashes from 5 to 10 times, then release the button.
-
Page 11: Glossary
Glossary CAN - Control Area Network (digital network for data transfer in vehicles) CIP - Combined Instrument Panel GSM – Global System for Mobile GPRS – General packet radio service, packet oriented mobile data service LED - Light Emission Diode RCP - Remote Control Plug-in (electronic module for heater remote control) SIM –... - Page 12 © Autoplugin ES www.autoplugin.ru...
Need help?
Do you have a question about the Therminal-V3 and is the answer not in the manual?
Questions and answers