Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Autoplugin RCP-V2
Summary of Contents for Autoplugin RCP-V2
- Page 1 Autoplugin RCP-V2 Installation Manual Rev A...
- Page 2 Figure 1 Ground Service connector Autoplugin RCP-V2 1 2 3 4 5 6 7 8 9 10 1 2 3 4 5 6 7 8 9 Brown Brown-white White to scheme of turning off Grey Green to scheme Blue of turning on...
- Page 3 Table of Contents Installation procedure for plug-n-play connection………………………………. Connection schemes for permanent connection ………………..……………….. Installation procedure for permanent connection………………...…….……...… Troubleshooting…………………………………………………...……………... Installation procedure for plug-n-play connection · Find the service connector at the left side of the dashboard, below the lighting control switch. ·...
- Page 4 You can connect and use set of devices as a remote control of the fuel-fired heater: specialized heater remotes (such as Telestart, EasyStart, Smart Start), additional alarm systems remote controls, GSM mobile phones in conjunction with automotive GSM-modules, etc. If the remote control has output channels that give short impulses in active state, it is possible to apply the schemes given at fig.
- Page 5 Battery+ White Grey Green Blue to RC Figure 6 · Connection of the input RC_in o The input RC_in is intended for connection of specialized remote controls such as DEFA Smart Start, Hydronic Easy Start, Webasto Telestart. If direct connection of remote control’s output line to the input RC_in is not functional, the scheme at the fig.7 can be applied.
- Page 6 · Alerts receiving If the remote control unit has got inputs to obtain information about the heater operation, they can be connected to the RCP’s outputs Alert_1 and Alert_2. The outputs have negative polarity. Therefore if remote control unit not fit it, it needs to apply a matching circuit (with relay ex.).
- Page 7 · Connect both connectors to the module (X2 should be connected first) · Test the heater start from the module · Fix the module using double-sided adhesive tape · Install interior elements in the reverse order of removal · Adjust the module in the programming mode if it necessary. Make notes in the programming table of the user manual about the adjustments 4) Troubleshooting If you have problems with module operation, first of all check indication of the...
- Page 8 CAN- bus or is out of order Unknown CAN-bus type has not Check for compatibility of RCP CAN-bus been determined module with the car. Try to set the CAN-bus code manually* * Information available on request © Autoplugin ES www.autoplugin.ru...
Need help?
Do you have a question about the RCP-V2 and is the answer not in the manual?
Questions and answers