Sanyo PLS-2400 Phone Manual page 150

Tip:
You can also make a Group Call after checking the group member.
Press to display group members, highlight <Call Group> and press and
hold
Tip:
To redial your last Press&Talk call, highlight Redial and press and hold
from the Press&Talk List.
Making a Press&Talk Call by Entering a Number
To place a Press&Talk call by entering a number:
1.
From standby mode, enter the Press&Talk number you
want to dial.
2.
Press
holding
3.
Continue with the Press&Talk call, pressing and holding
4.
When the call is finished, press
– or –
1.
Press P&T (left softkey) or press
2.
Press Go to (left softkey), highlight Enter P&T# and press
3.
Enter the Press&Talk number you want to dial.
4.
Follow steps 2–4 above.
Note:
Press&Talk numbers must contain 10 digits (area code + phone
number) or 11 digits (1 + area code + phone number). Your Press&Talk
number is the same as your wireless phone number.
136 Section 2I: Using Press&Talk
during step 3 above.
to place the Press&Talk call. Continue
to take the floor and speak.
The contact's name appears on the display if there is
a matched number in your Press&Talk List.
to speak and releasing it to allow others to reply.
.
.
.