Page 1
DURACAP TRUCK TOPPER RACK ™ Use these instructions to install DURACAP Truck Topper Rack. Read and follow these ™ instructions along with the standard instructions carefully before installing or using rack. NOTICE TO INSTALLER: Even if familiar with product, read instructions prior to installation as improvements may be made without notice.
Page 2
WARNING DURACAP™ Truck Topper Racks have a static load capacity of 1000 lbs., a dynamic load capacity of 500 lbs. and an off-road dynamic load capacity of 400 lbs., evenly distributed on DURACAP™ Truck Topper Rack System including accessories. Always secure cargo properly.
• Always drive cautiously with cargo on DURACAP Truck Topper Rack. Additional weight ™ changes dynamics of driving. • Be aware of total vehicle height and width with DURACAP Truck Topper Rack and ™ cargo, ensure safe passage under any low clearances.
Page 4
1: INSTALLING CROSS BARS NOTE: Skip to Step 1C if installing rack along with DURACAP Hard Truck Topper. ™ A. On one side, at the front, remove (2) nylock flange nuts, carriage bolts and bolting plate. Carriage bolts B. Repeat for opposite side.
Page 5
1: INSTALLING CROSS BARS (Continued) H. With cross bar installed on roof, center Equal on End cap cross bar on topper, then fully tighten nylock both sides flange nuts. Cross bar I. Repeat for remaining cross bar. J. Thread 3/8” x 3/4” hex bolt from bottom of end cap bolt hole into channel nut.
• Replace damaged parts. NOTE: Inspection and/or maintenance should also be performed anytime a malfunction is observed or suspected. If you need assistance inspecting and/or servicing your DURACAP Truck Topper Rack call Customer Service at ™ 888-568-3709. If you want to order a replacement part, call Customer Service or visit duracapparts.com.
MANUFACTURER’S LIMITED WARRANTY Agri-Cover, Inc. extends the following one (1) year Limited Warranty for the DURACAP ™ Truck Topper Rack: Agri-Cover, Inc. warrants a period of one (1) year from the date of manufacture that its DURACAP Truck Topper Rack is free from defects in workmanship under normal use for ™...
Need help?
Do you have a question about the DURACAP and is the answer not in the manual?
Questions and answers