velorian E-BIKE BLINKERSET 2.0 Plug & Ride Manual

© velorian GmbH, Storkower Str. 115A, 10407 Berlin, Germany - https://velorian.de/ velorian Blinkerset Plug & Ride
E-BIKE
BLINKERSET 2.0
Plug & Ride
Installation
General Safety Instructions
The velorian e-bike blinkerset 2.0 contains small parts that can be swallowed by little children. There is a risk of injury when handling
the cables and tools.
We recommend installation by a specialist workshop.
The electronics in the blinkerbox are reverse polarity protected. This means that swapping the connection cables (mixing up plus and
minus) on indicators, switches or the power supply will not destroy the electronics or the connected components.
Scope of delivery
In addition to the individually packaged components, all cables and splitters are packaged together with the indicator box.
This includes:
(A) 50 cm cable 6-pin (violet) to the front of the handlebars
(B) 50 Cable cm 3-pole (yellow) to the rear
(E)
(D)
(C) 10 cm cable 3-pin (yellow) extension to the rear
(D) a cable splitter for connecting the front indicators and switches or buttons
(E) one 3-pin to 2x2-pin cable splitter for the rear indicators
The extension cables are available in different lengths to adapt to the respective frame size.
See https://shop.velorian.de/Cable-and-Splitter-Plug-and-Ride
General installation instructions
The blinkerbox is splash-proof. Nevertheless, the side with the two cables and the opening of the sounder should be attached in such
a way that no water can collect on the sounder. This side should point downwards.
Make sure that the plug and socket are correctly aligned before making the connection! Otherwise,
the pins could bend when plugging together, especially the multi-pin plugs.
The following illustration shows the imaginary cable route on the bike from the handlebars along the
dash-dot line with the mounting position of the indicator box on the seat tube above the bottom
bracket to the luggage rack.
Version EN.01.2024.10.22 page 1/6