Product Overviews...................10 Preparation before Operation................13 Examining Features ..................15 Operating the dehumidifer................17 Using the Extra Functions ................19 Emptying the Bucket ..................21 SMART FUNCTIONS LG ThinQ Application ..................25 Smart Diagnosis ....................26 MAINTENANCE Maintaining the Product .................28 TROUBLESHOOTING Before Calling for Service................31 APPENDIX...
SAFETY INSTRUCTIONS SAFETY INSTRUCTIONS READ AND SAVE THESE INSTRUCTIONS The following safety guidelines are intended to prevent unforeseen risks or damage from unsafe or incorrect operation of the appliance. The guidelines are separated into ‘WARNING’ and ‘CAUTION’ as described below. Safety Messages This symbol is displayed to indicate matters and operations that can cause risk.
SAFETY INSTRUCTIONS responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. • If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person in order to avoid a hazard.
SAFETY INSTRUCTIONS Operation • If the appliance is immersed in water, stop using it and contact an LG Electronics Customer Information Center. • If there is a gas leakage (isobutane, propane, LNG, etc.), do not touch the appliance or power plug and ventilate the area immediately.
Page 6
SAFETY INSTRUCTIONS • This product uses UVnano LED. Do not disconnect or replace the UVnano LED arbitrarily. LEDs must be replaced only by LG-approved service providers. • Harmful UVnano radiation may leak if the device is used in an unintended way or if the wires are damaged. UVnano radiation, even in very small amounts, can harm the eyes and skin.
SAFETY INSTRUCTIONS CAUTION INSTRUCTIONS CAUTION • To reduce the risk of minor injury to persons, malfunction, or damage to the product or property when using this product, follow basic precautions, including the following: Installation • Do not tilt the appliance to pull or push it when transporting. •...
Page 8
SAFETY INSTRUCTIONS • Do not operate the appliance with wet hands. • Do not use the appliance while it is not in an upright position. • Do not use the appliance near objects vulnerable to heat. • Do not use detergents, cosmetics, chemicals, air fresheners, or disinfectants in the appliance.
Page 9
SAFETY INSTRUCTIONS • Wear gloves when cleaning the Product and removing the filter cover, and be careful not to injure yourself on sharp parts (such as the heat exchanger). • Do not clean the heat exchanger arbitrarily. Doing so may result in injury.
OPERATION OPERATION • The exterior or components of the product may vary depending on the model. Product Overviews Front Control Panel/Status Panel • Sets the appliance functions. • Checks the settings of the appliance. Pop-up Handle • When you press it, a handle comes out. Louver •...
Page 11
OPERATION Back Pre-Filter Air Inlet • Absorbs the air and moisture in the room. Drain Cap Hose cover • You can use the drying kits using the extension hose adapter. Humidity Sensor • Detects humidity in the air. Power Plug Storage Power plug Wheels...
Page 12
OPERATION Components Extension Hose Adapter • This Adapter is for connecting the extension hose to the product. Extension Hose Shoes Drying Kit Laundry Drying Kit NOTE • The extension hose adapter, extension hose and drying kits are stored in the buffer on top of the product.
OPERATION Preparation before • Even in the same space, the humidity may varies depending on the air circulation. Additionally, Operation the humidity may differ from the humidity measured by other products and hygrometers. Checklist Before Usage • Dehumidification amount varies depending on Transportation Requirements the indoor temperature and humidity.
Page 14
OPERATION • If there is not enough room for air suction, the dehumidification performance may be affected. • Do not install the product near direct sunlight or bright lighting. - Doing so may cause discoloration of the product.
Controlling the Dehumidifier Control Panel Start/Stop Button Turns the product on and off. • To prepare the product to connect to Wi-Fi through the LG ThinQ application, press and hold the button for 3 seconds. Mode Button Sets the operating mode.
OPERATION Status Panel Icons Icon Description Lights up when the ionizer function is activated. Lights up when the UVnano function is activated. Lights up when the Wi-Fi function is established. Lights up when the control panel is locked. Set Indicator •...
5 seconds. After that, the current humidity will be displayed. • You can adjust fan speed by using the LG ThinQ Silent Mode application. • You can adjust the airflow by using the LG ThinQ Use when you want to operate dehumidification application.
OPERATION • Use the product by connecting shoes drying kit/ • When using the Laundry mode, is displayed laundry drying kit through the extension hose as on the status display for a moment. necessary. How to use Spot Mode Open the hose cover at the back of the product by pressing the left triangle of the hose cover.
OPERATION triangle markings are facing the same • If you press the Humidity button, the direction. desired humidity will change in the order of 30 & & & & & & & & NOTE After inserting extension hose into the •...
1 Cancel. NOTE • Using the LG ThinQ application, you can change NOTE the lighting color and brightness. • To see the remaining time, press the Timer button after the humidity is displayed on the status display.
• When the full water is detected, the sterilizing 99.99 % of bacteria on the surface. dehumidification function immediately stops • Using the LG ThinQ application, set the UVnano and fan operates for 5 minutes to remove the function. remaining condensed water in the heat exchanger.
Page 22
OPERATION How to Empty the Bucket • When inserting the bucket, do not put your hand over the bucket handle. Hold the top handle of the bucket and softly take it out. CAUTION • If the water tank is taken out right after stopping the operation, there are cases of water remaining in the heat exchanger dropping into the main unit.
Page 23
OPERATION How to Continuous Drainage Insert the continuous drainage hose( ) into Setup the continuous drainage hole and connect it to the drain hole on the product. Required items: 16mm (inner diameter) hose Hold the top handle of the bucket and softly take it out.
Page 24
OPERATION NOTE • The continuous drainage hose is sold separately. If you wish to use a commercial hose available in the market, use a hose whose internal diameter is 16mm. • Check if the continuous drainage hose is connected to the drain hole on the product correctly.
To check your network frequency, contact your Internet service provider or refer to your wireless router manual. Before Using LG ThinQ • LG ThinQ is not responsible for any network connection problems or any faults, Application malfunctions, or errors caused by network connection.
Installing the LG ThinQ LG ThinQ application. Application • Launch the LG ThinQ application and select the Smart Diagnosis feature in the menu. Follow Search for the LG ThinQ application from the the instructions provided in the LG ThinQ Google Play Store or Apple App Store on a application.
Page 27
When data transmission is complete, the Smart Diagnosis result will be displayed on the LG ThinQ Application. NOTE • For accurate diagnosis, do not move the smartphone away from the product until the beeping stops.
MAINTENANCE MAINTENANCE Maintaining the Product labels on the exterior. Doing so may damage the product surface. Cleaning the Exterior • Care should be exercised to prevent flowing of water into the product. Remove dust using a vacuum cleaner. Cleaning the Bucket Press the fixing part on both sides of the bucket to take out the lid.
MAINTENANCE • Do not use hot water, detergent, air fresheners, Completely dry the filter in shade, reassemble surfactants, antistatic agents, etc. It may the filter and filter cover to the product. damage the exterior of the product. Cleaning the Filters Press the top of the filter cover to remove the filter cover from the product.
Page 30
MAINTENANCE • Organize the power cord using the Velcro CAUTION attached to the power plug. • Do not store the appliance at a humid place or at a place exposed to the direct sunlight. Otherwise the appliance may be deformed, malfunction or generate odor.
TROUBLESHOOTING TROUBLESHOOTING Before Calling for Service Please check the following before calling for service. If the problem persists, contact your local service center. Normal Operating Sounds of the Product Sound of wind The volume of sound changes according to the angle of the louver. 'Buzzing' and 'grr-grr' (grinding) sounds Sound may be heard until the circulation of the refrigerant stabilizes.
Page 32
TROUBLESHOOTING Symptoms Possible Cause & Solution The appliance does not Did the electricity get cut off? operate. • Check the power to other products in the house. Is the bucket correctly installed? • Install the bucket correctly. Is the Bucket indicator light up? •...
Page 33
The extension hose is Is the extension hose adapter connected to the product? not connected. • Check the extension hose adapter is connected. LG ThinQ Symptoms Possible Cause & Solution The product and the Is the Wi-Fi password used to connect to the smartphone correct? smartphone cannot be •...
APPENDIX APPENDIX Information APPLIANCE SPECIFICATIONS • Appearance and specifications may vary without notice to improve the quality of the appliance. Name DD**GM*E* Power AC 220 V ~ 50 Hz Exterior Dimensions 410 mm x 210 mm x 640 mm...
Need help?
Do you have a question about the DD GM Series and is the answer not in the manual?
Questions and answers