Table of Contents
Advertisement
REPEAT A B Function
Press REP. A B button.
•
Use this to listen to a specific section again during playback.
•
Set the start and end points of the section you want to repeat 3 times.
•
This is a useful when learning a foreign language.
•
The TAPE REPEAT function can be used only on sections that are longer
than 7 seconds.
Note
•
You cannot set the end point (B) within 7 seconds after
setting the start point (A).
Selecting the Cassette Playback Mode
Your micro component system has three cassette playback modes which enable
you to listen to both sides of a cassette automatically.
Press REV.MODE until the appropriate symbol is
displayed.
•
: One side of the selected cassette and then stops.
•
: One side of the cassette.
The other side of the cassette and then stops.
•
: Both sides of the cassette indefinitely until you press stop.
Tape Counter
When playing a cassette, a counter is displayed to enable you to take note of the counter
value at the start of each track and thus start playback at the beginning of the track to
which you wish to listen.
•
The counter is only displayed when a cassette is being played.
Before starting to record a cassette for which you wish to take note of the
counter values at the beginning of each track, reset the counter by pressing
Counter Reset.
46
Advertisement
Table of Contents
