Table of Contents
Advertisement
Listening to a Cassette
Always treat your cassettes with care; refer, if necessary, to the section entitled
"Precautions When Using Audio Cassettes" on page 56.
1
2
Switch the system
Press TAPE on
on by pressing
the player to
POWER.
select the Tape
function.
Press the
4
5
Press the
button. The cassette
button if necessary.
starts playing.
•
•
Side A : Tape (
) button once.
Rewind the cassette
•
button.
Side B : Tape (
) button twice.
•
Fast-forward the cassette UP /
button.
45
Press the PUSH
3
EJECT (
) of the
cassette deck to open
the cassette door and
insert a cassette.
•
Insert a cassette with the
recording/playback side facing
the cassette holder, and then
push the cassette door shut.
When you have
6
,
finished playback,
press STOP button.
/ DOWN
REPEAT A B Function
Press REP. A B button.
•
Use this to listen to a specific section again during playback.
•
Set the start and end points of the section you want to repeat 3 times.
•
This is a useful when learning a foreign language.
•
The TAPE REPEAT function can be used only on sections that are longer
than 7 seconds.
Note
•
You cannot set the end point (B) within 7 seconds after
setting the start point (A).
Selecting the Cassette Playback Mode
Your micro component system has three cassette playback modes which enable
you to listen to both sides of a cassette automatically.
Press REV.MODE until the appropriate symbol is
displayed.
•
: One side of the selected cassette and then stops.
•
: One side of the cassette.
The other side of the cassette and then stops.
•
: Both sides of the cassette indefinitely until you press stop.
46
Advertisement
Table of Contents
