Auto Sound Calibration Setup - Samsung HT-TXQ120K Instruction Manual

Auto Sound Calibration Setup

This function is available only for DVD/CD playback.
Auto Sound Calibration
By setting the auto sound calibration function just once when you relocate or install the unit, you can have the unit
automatically recognize the distance between speakers, levels between channels, and frequency characteristics to create
a 5.1-channel sound fi eld optimized for the listener's environment.
* The following images are for illustrative purposes only and may
differ from the actual product.
• If you have not perfomed the ASC function, pressing the Auto Sound Calibration button without connecting the auto sound
calibration microphone will display the message <PLEASE SET ASC FUNCTION> in the display.
• Because the volume level of the tone is fixed during the auto sound calibration setup, you cannot adjust the volume using
the volume control buttons.
• If the auto sound microphone is disconnected during the auto sound calibration setup, the setup will be cancelled.
• Since the ASC function does not work when a normal microphone is connected, unplug a normal microphone to use
the function.
56
L: Front Speaker (L) R: Front Speaker (R)
C: Center Speaker SW: Subwoofer
SL: Rear Speaker (L) SR: Rear Speaker (R)
1
Connect the auto sound calibration microphone to the auto sound
calibration input connector on the subwoofer.
2
Place the auto sound calibration microphone at the listener's position.
3
Press the Volume Control buttons on the main unit to make adjustments
as below.
If the distance between the listener and the speaker is over 5 m: Set the main unit's
volume to over 25.
If the distance between the listener and the speaker is 3 to 5 m: Set the main unit's
volume to 25.
If the distance between the listener and the speaker is less than 3 m: Set the main unit's
volume to 15.
4
Press the ASC button.
To create the optimal 5.1 channel sound filed, the selections are in the following
sequence: L
A tone is output.
The auto sound calibration setup takes about 2 minutes to complete.
5
When the message <REMOVE MIC> appears in the display, unplug the
auto sound calibration microphone.
To cancel the auto sound calibration setup, press the ASC button.
The tone output stops, <CANCEL ASC> appears in the display followed by <REMOVE
MIC>, and the setup is cancelled.
To listen in the auto sound calibration mode, briefly press the ASC button.
The selection alternates between <ASC ON> and <ASC OFF> in the display.
A result for each speaker is
If you select <ASC ON>, you will hear sound in the auto sound calibration mode.
displayed.
If you select <ASC OFF>, you will hear sound in the mode set in the audio setting of the
setup screen.
To Turn the Sound Logo On/Off
When you turn on the power, the unit produces a sound logo after the disc is read to notify that the unit is optimized for
playback.
1
Press and hold the ASC button.
<S.LOGO ON> or <S.LOGO OFF> appears in the display.
2
Briefly press the ASC button.
Each time the button is pressed, the selection alternates between <S.LOGO ON> and
<S.LOGO OFF>.
If you select <S.LOGO ON>, a sound logo will be output when the disc reading is fin-
ished after power-on. If you select <S.LOGO OFF>, no sound logo will be output.
C R SR SL SW
GB
57