Connecting The Video Out To Your Tv - Samsung HT-TXQ120K Instruction Manual

Connecting the Wireless Receiving Amplifier
Resetting the Wireless Receiving Module
Reset the system if a communication failure occurs, or if the Link indicator (blue LED) on the wireless receiver does not
light up and the "REAR CHECK" message blinks on the main unit's display.
Reset the system while the main unit and the wireless receiver module (SWA-3000) are in Power Standby mode.
1
With the main unit turned off, press and hold the remote
control's REMAIN button for 5 seconds.
2
With the wireless receiver module turned on, use a ball point pen
or a toothpick to press the RESET button on the back of the unit.
3
Turn on the main unit.
• When the wireless receiving module setting is complete, no audio signal is output from the Rear Speaker Output
Connector on the back of the subwoofer.
• The wireless receiving antenna is built into the wireless receiver module. Keep the unit away from water and
moisture.
• For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any
obstructions.
• Sound will be heard from the wireless rear speakers in DVD 5.1-CH or Dolby Pro Logic II mode only.
• In 2-CH mode, no sound will be heard from the wireless rear speakers.
• Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the
main unit, some sound interruption may be heard due to interference.
• If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device that uses the
same frequency (2.4GHz) near the system, some sound interruption may be heard due to interference.
• The transmission distance of a radio wave is about 10m, but may vary depending on your operating environment.
If a steel-concrete wall or metallic wall is between the main unit and the wireless receiver module, the system may not
operate at all, because the radio wave cannot penetrate metal.
18
The STANDBY LED on the front panel of the wireless receiver module blinks.
The STANDBY LED on the front panel of the wireless receiver module blinks
2 Times.
The LINK LED of the wireless receiver module is lit and the Reset is complet-
ed.
If Power Standby mode continues, repeat Steps 1 to 3 above.

Connecting the Video Out to your TV

(Con't)
Choose one of the three methods for connecting to a TV.
ASC IN
Rear of
Subwoofer
METHOD 1 : HDMI ....... (Best Quality)
Connect the supplied HDMI cable from the HDMI OUT jack on the back of the main unit to the HDMI IN jack on your TV.
METHOD 2 : Component ....... (Better Quality)
If your television is equipped with Component Video inputs, connect a component video cable(not supplied) from the
Component Video Output (PR, PB and Y) Connectors on the back of the subwoofer to the Component Video Input
Connectors on your TV.
METHOD 3 : Composite Video ....... (Good Quality)
Connect the supplied video cable from the VIDEO OUT jack on the back of the subwoofer to the VIDEO IN jack on your
TV.
• This product operates in Interlace scan mode (576i, 480i) for component output.
METHOD2 METHOD 3
(supplied)
SPEAKERS OUT
FRONT R CENTER FRONT L
REAR R REAR L
KARAOKE MIC RADIO ANT.
MIC 1 MIC 2
COMPONENT OUT
SYSTEM CONNECTOR WIRELESS
R L
AUX IN VIDEO OUT
GB
TV
METHOD 1
(supplied)
Rear of
Main unit
19