Zamp Solar 30AD Deluxe Quick Start Manual

Install Safety:
- Inspect the installation area for safety hazards
- Be sure to remove all metal, such as rings and other jewlery
- Dissconnect all power sources and ensure solar panels are completely
- covered by a box or blanket until installation is complete
Install Instructions:
1. Arrange the layout of your panels and wires, ensuring that:
- 3-port roof cap is no more than 15' from charge controller
- panel leads can reach 3-port roof cap
- charge controller is no more than 9' from battery
- panels are not shaded by vents, AC units, or other
- obstructions
2. Connect 15' Solar wire(s) to the 3-port roof cap(s).
- Strip the ends of both positive and negative wires 1/2 inch
- Screw the red (+) wire into corisponding positive terminal,
black (-) wire into corisponding negative terminal.
3. Mount 3-port roof cap and route the 15' cable from roof to charge
controller location *Do not make connections at this time
4. Proceed to route the 10' cable from the charge controller to the
battery *Do not make connections at this time
5. Connect the positive solar wire to the charge controller, then connect
the positive battery wires to the controller (1 red terminal on BAT 1, 1 red
terminal on BAT 2).
6. Stack the negative wires on the charge controller (solar wire on bottom,
battery wires on top)
7. Mount your charge controller
8. Attach mounting feet to panels and proceed with panel installation.
9. Connect positive wire to battery and repeat with negative wire
10. You may now plug the SA E leads into the 3-port cap and uncover your
panels
11. You are now charging your battery.
12. Configure your charge controller to the proper battery type(s)
30AD Deluxe Roof Mounted Quick Start Guide
Fuse Blocks
Fuse Block