Related Manuals for Zamp Solar ZS-30AD
Summary of Contents for Zamp Solar ZS-30AD
- Page 1 Dual Battery Solar Controller Nominal Voltage: 12Volts Rated Solar Current: 30Amps Model Number: ZS-30AD User’s Manual...
- Page 2 FEATURE ●Fully independent dual battery charging control, reduce the extra cost of two separated solar charging system, ideal for Caravans, RVs, Boats and Cottages, etc. ●Charging priority preset, can select the percentage of available charge current to each battery. ●Provide a wide range of Battery type setting for each battery: Gel, AGM, Conventional lead-acid (WET), Calcium, LiFePO4, LTO (Lithium Titanium Oxide) Battery types selection.
-
Page 3: Mounting The Device
● This charger is designed for indoor use only and should never be exposed to rain. ● Do not disassemble the controller. Take to a qualified person if the unit requires repairing. ● Lead acid batteries, LiFePO4 or LTO batteries can be dangerous. Ensure no sparks or flames are present when working near batteries. -
Page 4: Wiring Connections
WIRING CONNECTIONS Refer to the wiring diagram below. Battery Connection Solar Array Connection Length of < 1m Wire Size (AWG) 8 or 6 Installation procedure: 1. Using the Terminals supplied, crimp the terminals on your Battery wires. 2. Connect together the Negative polarity of solar controller “-“, BAT1 “-“ and BT2 “-“ 3. - Page 5 Caution 2: The dual battery controller installation must be made by specialized technique person, any wrong size of wires used or loose power connections or corroded wires can melt wire insulation, burn surrounding materials or even cause a fire. Ensure tight all connections and use cable clamps to secure cables.
-
Page 6: Charging Stages
Press Battery type button BT1 and hold for 5 seconds to go into your battery 1# type selection mode, the battery 1# type you select will be shown on the LCD meter, the default setting is AGM Battery; the controller will automatically memorize your battery 1# type setting;... - Page 7 Soft Charge- When batteries suffer an over-discharge, the controller will softly ramps the battery voltage up to 10V. Bulk Charge-Maximum current charging until batteries rise to Absorption level Absorption Charge-Constant voltage charging and battery is over 85%. Equalization Charge*-Only for WET battery or Calcium battery type, when the battery is deeply drained below 10V, it will automatically run this stage to bring the internal cells as an equal states and fully complement the loss of capacity.(Gel, AGM,LiFePO4 and LTO battery do not run Equalization...
- Page 8 LED indications Solar panel abnormal LCD backlight mode display Solar panel reverse Flash Flash connection Solar panel over voltage Flash Flash (Vs > 26.5V) Solar panel weak Flash (Vs < Vbt1 or Vbt2) LED indications Battery abnormal mode LCD backlight display Battery disconnected or Flash Flash...
-
Page 9: Specifications
As an option, the unit also provides a port to connect the external Remote display meter for some special location needed. The display content on the Remote meter is same as the display on the controller. SPECIFICATIONS Electrical Parameters Rated solar panel amps Max.